Parts

433 MHz transmitter, FS1000A

The FS1000A: a 433 MHz on-off radio transmitter with three pins. DATA high is the carrier on, and every receiver on the canvas hears it.

This part has a page of its own, with a note on using it and a circuit to try: the part page.

Aliases: FS1000A, MX-FS-03V, 433 MHz transmitter, RF transmitter, ASK transmitter, OOK.

It comes in a pair with the XY-MK-5V receiver, in nearly every Arduino kit, and drives remote-controlled mains sockets, doorbells and weather stations.

Pins

Pin What it does
DATA High switches the 433.92 MHz carrier on, low switches it off. A 3.3 V or a 5 V board pin drives it.
VCC Supply, 3 to 12 V. More volts is more range on a real one.
GND Ground.
ANT The antenna pad, and the air every 433 MHz module on the canvas shares. Leave it unwired.

How it works

There is no chip on the board: a SAW resonator sets the frequency and one transistor oscillates at it while DATA is high. So the module knows nothing about bits or bytes. The sketch makes every pulse itself, with exact timing, and a library does that for you:

  • RCSwitch.h (rc-switch) sends the codes remote sockets and doorbells use: mySwitch.enableTransmit(10), then mySwitch.send(5393, 24) or mySwitch.switchOn("11111", "00010").
  • RH_ASK.h (RadioHead) sends whole messages with a checksum: driver.send(data, len) and driver.waitPacketSent(). Its transmit pin is 12 by default.

This way of sending is called ASK (amplitude shift keying), or OOK (on-off keying) when the carrier is simply on or off.

Every 433 MHz module on the canvas shares the air

Put a transmitter and a receiver down, wire each to its own board, and the receiver's DATA follows the transmitter's, with no wire between them. Mokxi joins the ANT pad of every 433 MHz module on the canvas into one line, the room. Two transmitters keyed at the same time spoil each other's codes, as on the bench. The 433 MHz pair does not hear an nRF24L01 or a LoRa module: each has an air of its own.

What is not modeled

Distance, walls and the antenna: every receiver on the canvas hears every transmitter at full strength. That is right for a desk; the real pair reaches about 20 to 100 m in the open with a 17 cm wire on ANT. The 315 MHz version is the same part on another frequency, and here all modules share one. The carrier switches at once, where a real one takes some tens of microseconds, and the supply current (about 10 to 40 mA while sending) is not drawn.

Common mistakes

Holding DATA high. The carrier stays on and blocks every other transmitter nearby. rc-switch and RH_ASK leave the pin low after each message.

No receiver noise in mind. A real receiver prints garbage when nothing is sending; see the XY-MK-5V page.

RH_ASK with Servo.h on an Uno. Both want Timer1, and the build fails.