Before you start
This is an advanced course. The op-amp gain formulas belong to Transistors and op-amps for real, RC corners to AC, signals and filters, the difference amp to the Op-amp circuit cookbook, and the push-pull stage itself to Discrete transistor design. This course builds on them rather than teaching them again.
Take the course Audio electronics on /learn.
The bench
Every circuit runs on +12 V and -12 V rails with TL072 op-amps and TIP41C and TIP42C power transistors. The guitar is a function generator playing A440 behind a 10 k resistor, standing in for a pickup's own resistance; a real pickup is also a large inductance, which the stand-in leaves out. The speaker part is a resistive 8 ohm load (its live value is the note it plays); a real cone's impedance rises with frequency.
Steps are graded from meters: AC volts read true RMS, trustworthy to about a kilohertz, so every graded frequency is at or under 1 kHz. Clipping shows up as an RMS reading that falls short of the clean one, and the scope shows the shape. The simulator does not model resistor hiss.
The lessons
- Preamps: gain in dB, input impedance, headroom and a log volume pot.
- Tone controls: a guitar's treble cut at 723 Hz and a bass cut at 159 Hz.
- Amplifier classes: where the watts go in class AB and class A, and why class D exists.
- Distortion: soft clipping, compression, asymmetric clipping and hard clipping at the rails.
- Speakers and impedance: watts into 8 and 4 ohms, cable loss, damping factor, and decibels.
- Hum and noise: a ground loop, a balanced input, filtering that only half works, and the grounding rules.
- Boss build: a class A guitar amp channel: gain, overdrive, tone and a class A output stage into a speaker.
Safety
Everything here is low voltage. Real guitar amps, especially tube amps, have lethal voltages inside, even unplugged: their capacitors hold a charge. Never remove or defeat a mains safety ground to cure hum.