Lessons and the learning game

DC circuit analysis

Solve resistor networks on paper and prove every answer on the meters, from Kirchhoff's laws to Thevenin, Norton and a Wheatstone bridge boss.

What the course covers

DC circuit analysis is eight lessons, one chapter each, with a quiz after every chapter:

  1. KVL: every loop adds to zero, two sources aiding and opposing, and a resistor chosen so a drop lands on a target.
  2. KCL: current in equals current out, branch currents read off each resistor, and a resistor solved with conductances.
  3. Series-parallel reduction: series adds, parallel is product over sum, and an R-2R ladder that halves the voltage at every node.
  4. Thevenin: open-circuit voltage, short-circuit current and resistance with the source off, all on one meter, then an equivalent that matches the real network under any load.
  5. Norton: the same network as a current source and a resistor, source transformation, and compliance voltage.
  6. Superposition: one source at a time, scaled and reversed shares, and why power does not add.
  7. Max power transfer: the matched load, the 50 percent efficiency that comes with it, and matching a real network.
  8. Boss: solve and verify a network: a Wheatstone bridge solved on paper, verified on the meter, balanced, and turned into a strain gauge sensor.

How it checks your work

There is no microcontroller in the course. The simulator solves each circuit, and steps check a multimeter reading or a resistor's live value, which is its current. Most steps ask you to predict a number first, then change a part and run it.

What the simulation is and is not

  • Mokxi has no ideal current source part. The Norton lesson uses a bench power supply in constant-current mode, as a real bench does: it pushes its set current up to its voltage setting, and settles within a fraction of a percent of it.
  • Sources are ideal and the meters barely load the circuit (10 M on volts), so readings match the math. The Measurement and instruments course covers what a real meter's resistance does.
  • An ohmmeter must never see a live source: the lessons set a source to 0 V before measuring resistance, which is what "switch it off" means here.

Math for electronics for rearranging Ohm's law, Power and batteries for Ohm's law on a meter, and Know your components for reading the resistors themselves.