Take the course at /learn/path/displays-first-steps. It is a beginner course: it assumes only the Uno course and explains every idea from scratch.
The lessons
Characters. A 16x2 LCD on six wires (RS, E, D4 to D7 in four-bit mode) counts down a rocket launch, draws the rocket as a custom character and shows a live temperature. Then the same LCD on its PCF8574 I2C backpack: a bus scan, what an address is, what happens with the wrong one, and a scrolling marquee with a walking alien.
Digits. One bare common-cathode digit on seven pins: a segment test, a digit as a byte, a font as an array of bytes, a dice roll, and counting in hex. Then a TM1637 four-digit module as an escape room timer, with a blinking colon, brightness and DONE spelled in raw segments.
Dots and driver chips. A MAX7219 8x8 matrix with a two-frame marching space invader, each row a byte written in binary. Then an HT16K33 four-digit display sharing the I2C bus with two sensors, showing the temperature with a degree sign and blinking a warning.
Project. Button Mash Duel: press start, wait for GO, and mash. An HT16K33 shows the score as P1:P2, an I2C LCD runs the countdown and names the winner, both on one I2C bus, and the high score is saved in EEPROM.
The benches
Six lessons open a gallery circuit with a sketch of their own: the thermometer (parallel LCD and a TMP36), the I2C thermometer (I2C LCD), the electronic dice (bare digit and a button), the doomsday defuse board (TM1637, three buttons, three lamps and a piezo), matrix ball (MAX7219 matrix) and the air quality monitor (HT16K33, SHT31 and SGP30). The project has its own bench: an HT16K33, a 16x2 I2C LCD and three buttons on pins 2, 3 and 4.
What each sketch does
dsplcd: LiquidCrystal on pins 12, 11, 5, 4, 3, 2. A countdown fromCOUNT_FROM, a rocket in custom character slot 0, then the TMP36 on A0 in tenths of a degree.dspi2c: scans the bus, then LiquidCrystal_I2C atLCD_ADDRESS(0x27). Times a full screen over I2C (148 ms), then scrolls a marquee and walks a two-frame alien.dspseg: segments a to g on pins 2 to 8, a 16-entry font, a counter inBASE10 (or 16), and a dice roll on the pin 9 button.dsptm: TM1637Display on A0 and A1. A countdown fromSTART_SECONDS, start and pause on pin 6, ten more seconds on pin 7, brightness on pin 8, lamps on 2, 3 and 4, a beep on pin 10.dspmatrix: LedControl on DIN 11, CLK 13, CS 10. Two invader frames of 36 and 34 dots, half a second each.dspht: scans the bus (0x44, 0x58, 0x70), shows the SHT31's temperature on the HT16K33, and blinks it with the LED on pin 8 atWARN_TENTHS(28.0 C).dsparcade: the scoreboard, a four-state machine (ready, countdown, playing, over) with 20 ms debounced buttons and aROUND_SECONDSround.
Honest limits
- The displays draw what their chips are told, but there is no contrast trimmer on the six-wire LCD: V0 is tied to ground for full contrast.
- The temperature sensors are sliders, not air. The SHT31 reports in steps, so 23 C can read 22.9 C before rounding, as a real one does.
- EEPROM starts fresh each time you press Run, so the high score lives only for that run. On a real Uno it survives switching off.
Related
Talk to chips goes deeper into I2C and SPI, and OLED graphics moves from characters to pixels.