Lessons and the learning game

Protection circuits

The parts that keep a mistake, surge or fault from wrecking your electronics, ending in a 12 V input you harden against all of it.

What the course covers

Protection circuits is seven lessons, one chapter each, with a quiz after every chapter:

  1. Fuses and PTCs: a one-shot fuse against a resettable current limit.
  2. Reverse polarity: a series Schottky diode and a P-channel MOSFET.
  3. TVS and ESD: a surge clamped by a diode across the rail, the source resistance in front of it, and where ESD protection goes.
  4. Inrush limiting: a big input capacitor, a limiter sized against the fuse, its running cost, and a bypass.
  5. Flyback diodes: a plain diode clamp and a diode-Zener clamp.
  6. Crowbars: sense the overvoltage, short the rail, let the fuse clear it.
  7. Boss: a bulletproof power input: a fuse, a reverse-polarity MOSFET and a surge clamp, tested backward, surged and shorted, then retuned.

What the simulation is and is not

  • The multimeter's A jack has a real 2 A fuse, and the lessons use it as the input fuse.
  • There is no PTC, TVS, NTC or SCR part. A bench supply's current limit stands in for a resettable fuse, a Zener for a TVS, a resistor for an NTC's cold resistance, and a MOSFET for an SCR (which, unlike an SCR, does not latch).
  • The Zener and the MOSFET have no power ratings here; each lesson says what a real part would need. ESD is too fast to simulate, so that step is reading.

Wire, fuses and breakers for fuse curves, Power and batteries, and Magnetism and inductors for the coil kick a flyback diode catches.