Lessons and the learning game

Build reaction training pods

Lights you slap: touch pads, LED rings and a wireless pod, running random drills timed to the millisecond.

What you build

A set of three reaction pods, like the ones sprinters, goalkeepers and boxers train with. A hub picks a pod at random after a random gap, lights it green, and times how long you take to touch it. After ten lights it scores the session and keeps your best.

  • The hub: an Arduino Uno with pods A and B.
  • A pod: a TTP223 touch pad and an eight-LED WS2812 ring. Pod A is pad 2 and ring 5, pod B pad 3 and ring 6.
  • Pod C: a second Uno with its own pad and ring, out on the floor.
  • The link: an nRF24L01 radio on each Uno, in place of the ESP-NOW many commercial pods use.

How it works

Touch through plastic. The TTP223 feels a finger as a change of capacitance and drives SIG high, about 60 ms later. It ignores the pad for half a second after power-up.

Colors that mean something. Dim blue is waiting, green is go, red is a miss.

Timing at the pod. The hub radios pod C to light up. Pod C times the touch on its own clock and sends back only the result, so radio delays never count against the player.

Fair drills. Random pods and random gaps of one to two seconds, so nobody can learn the rhythm and guess. Typical human reaction to a light is about 200 to 250 ms.

Fair scores. A miss counts as the full 1500 ms in the average, so skipping hard lights never helps. The best average is kept in EEPROM.

The course

Build reaction training pods has six lessons, all on the same wiring:

  1. Touch pads: TTP223 pads and lit rings.
  2. Lights: blue, green and red.
  3. Pods talking: a wireless pod on nRF24L01.
  4. Drills: random lights, timed to the millisecond.
  5. Scores: averages, ratings and a record.
  6. Project: a training session: train, test the worst case, build your own.

Every step is checked against the running circuit, apart from the last, where you make the pods your own and share them.