What the course teaches
Build an orrery clock is six lessons on the Uno, in three chapters:
- The sky in numbers: orbital periods, mean longitude from the J2000 epoch with JPL's elements, and the equation of center that turns the mean into the true longitude, within about a degree for these four planets (the mean alone can be 24 degrees out for Mercury); steps a day for each arm, the best gear pair a clockmaker could cut, and why a float running total stalls where a 32-bit fixed-point fraction does not.
- The machine: an arm per planet on 28BYJ-48s and two 74HC595s, the shortest way around, and A3144 hall sensors that home every arm to the March equinox.
- Time and the project: days since J2000 from a DS3231, setting it in UTC, an equinox checked against the sky, and the project, the orrery set to today and wound forward with step accumulators checked against the formula.
It is a desk model, not an ephemeris. Homing and steppers in general are in Stepper motion planning. Each chapter ends in a short quiz. Open it from /learn.
The circuit
The orrery clock runs the orrdesk sketch:
- four 28BYJ-48s, Mercury, Venus, Earth and Mars, on two daisy-chained 74HC595s (DS 11, clock 12, latch 8)
- an A3144 hall sensor per arm on A0 to A3, under the 0 degree mark
- a DS3231 real-time clock on A4 and A5
The checks read the arms' shaft angles and what the sketch prints. To home, you play the magnets: slide each hall sensor's distance to 0.
Troubleshooting
- today prints but the arms do not move. Home first: slide the four hall sensors to 0, type home, then slide them back.
- The date is wrong. Type set with year, month, day and hour, in UTC, or set the DS3231's start property.
- An arm points a little off the printed value. One step is 0.176 degrees; the arms round to the nearest step.
Related
Build a split-flap display, another build on 28BYJ-48s, hall sensors and shift registers.