Take it on /learn as Oscillators and timing circuits.
The lessons
- 555 astable deep: frequency and duty formulas, a capacitor between a third and two thirds of the supply, and a diode that breaks the 50 percent floor.
- Monostable: one 1.1 s pulse per press, T = 1.1 RC.
- Schmitt oscillators: a 74HC14 gate with one resistor and one capacitor, and a second gate as a buffer.
- CD4060 dividers: an RC oscillator and fourteen halvings, up to a one-minute timer.
- RC phase shift: an LM358 inverter fed back through three RC stages, with a gain of at least 29.
- Wien bridge: the op-amp cookbook's Wien bridge on one 9 V supply.
- Boss: a steady tone generator: a 555 clocks a CD4060, which divides by 16 into an LM358 follower and a piezo. Tune it to 440 Hz, then drop an octave.
How it is measured
Every circuit runs with no microcontroller. A frequency counter reads each oscillator, a multimeter reads duty or AC volts, and a scope shows the waveforms. The LM358s have 1 mV of input offset set, as a real one has a few, which is what starts the sine oscillators.
Limits of the models
Real 555s and RC oscillators drift with temperature and their capacitors are often 10 to 20 percent off their labels, so tune with a counter. The CD4060's Schmitt input and protection diodes are not modeled. For timing you can trust, use a crystal.