All paths

Discrete transistor design

The building blocks inside every op-amp and audio amp, built from single transistors: current sources, mirrors, Darlingtons, the differential pair, push-pull stages, thermal stability, and a headphone amp of your own.

Free7 lessons6 h7 chapters1,917 XPElectrical · Advanced+250 XP

0 of 7 done

What you will build

0 projects, built step by step

7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.

The map

Chapter by chapter

Each lesson opens when the one before it is done, and each chapter ends in a project.

Chapter 1

Current sources

A transistor that holds a current, and its compliance.

  1. Open288 XP

    Current sources

    A transistor that holds a current whatever the load: diode bias, an emitter resistor that sets the amps, compliance, supply rejection, and a 1 mA source designed from scratch.

    0 of 6 steps

3 questions, graded as you go.
Chapter 2

Current mirrors

Copy a current, the Early effect, and degeneration.

  1. Locked288 XP

    Current mirrors

    Copy a current from one transistor to another: the diode-connected reference, a mirror that follows it, the Early effect, what a mismatched pair costs, and emitter degeneration that fixes it.

    0 of 6 steps

3 questions, graded as you go.
Chapter 3

Darlington and Sziklai

Gains multiplied, and what each pair costs.

  1. Locked288 XP

    Darlington and Sziklai

    Two transistors as one with the gains multiplied: a Darlington against a single part, its doubled base drop and high saturation, the Sziklai pair that keeps one Vbe, and a TIP120 that packs a Darlington in one case.

    0 of 6 steps

3 questions, graded as you go.
Chapter 4

Differential pair

A shared tail, gain from millivolts, common-mode rejection.

  1. Locked288 XP

    The differential pair

    Two transistors sharing one tail current: the balanced split, small-signal gain measured in millivolts, full steering, common-mode rejection, and the input stage of every op-amp.

    0 of 6 steps

3 questions, graded as you go.
Chapter 5

Push-pull

Class B, crossover, class AB and its idle current.

  1. Locked250 XP

    Push-pull output stages

    An NPN pushes and a PNP pulls: the dead zone of class B, crossover distortion, two diodes that bias it into class AB, its idle current, and a clean sine into a load.

    0 of 5 steps

3 questions, graded as you go.
Chapter 6

Thermal stability

Bias that survives heat, and thermal runaway.

  1. Locked265 XP

    Thermal stability

    Why a hot transistor draws more current, fixed bias that runs away with beta, divider bias with an emitter resistor that holds steady, the Vbe drift of 2 mV per degree, and the loop behind thermal runaway.

    0 of 6 steps

3 questions, graded as you go.
Chapter 7

Boss build

A two-stage discrete headphone amplifier.

  1. Locked250 XP

    Boss: a discrete headphone amp

    A common-emitter gain stage driving a class AB push-pull pair into a 32 ohm earpiece: check the bias, center the output, measure the gain and the power, then turn it up and find where it clips.

    0 of 5 steps

3 questions, graded as you go.
Syllabus

Every lesson in the course

All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.

Chapter 1

Current sources

  1. Current sourcesA transistor that holds a current whatever the load: diode bias, an emitter resistor that sets the amps, compliance, supply rejection, and a 1 mA source designed from scratch.
Chapter 2

Current mirrors

  1. Current mirrorsCopy a current from one transistor to another: the diode-connected reference, a mirror that follows it, the Early effect, what a mismatched pair costs, and emitter degeneration that fixes it.
Chapter 3

Darlington and Sziklai

  1. Darlington and SziklaiTwo transistors as one with the gains multiplied: a Darlington against a single part, its doubled base drop and high saturation, the Sziklai pair that keeps one Vbe, and a TIP120 that packs a Darlington in one case.
Chapter 4

Differential pair

  1. The differential pairTwo transistors sharing one tail current: the balanced split, small-signal gain measured in millivolts, full steering, common-mode rejection, and the input stage of every op-amp.
Chapter 5

Push-pull

  1. Push-pull output stagesAn NPN pushes and a PNP pulls: the dead zone of class B, crossover distortion, two diodes that bias it into class AB, its idle current, and a clean sine into a load.
Chapter 6

Thermal stability

  1. Thermal stabilityWhy a hot transistor draws more current, fixed bias that runs away with beta, divider bias with an emitter resistor that holds steady, the Vbe drift of 2 mV per degree, and the loop behind thermal runaway.
Chapter 7

Boss build

  1. Boss: a discrete headphone ampA common-emitter gain stage driving a class AB push-pull pair into a 32 ohm earpiece: check the bias, center the output, measure the gain and the power, then turn it up and find where it clips.
Kits

Build it on your bench too

Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.

Have a kit already?

Find your kit

Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.

See every kit
Questions

About Discrete transistor design

Is Discrete transistor design free?

Yes. All 7 lessons of Discrete transistor design are free and run in your browser, with nothing to install and no parts to buy before you start.

Do I need any parts?

No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.

How long does Discrete transistor design take?

About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.

Where do I start?

With "Current sources", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.