Before you start
This is an advanced course. The inverting and non-inverting amplifiers, the virtual ground and the comparator with hysteresis belong to Transistors and op-amps for real, and RC filters and the active low pass to AC, signals and filters. The cookbook links back to them rather than teaching them again.
Take the course Op-amp circuit cookbook on /learn.
The circuits
Every circuit runs on +12 V and -12 V rails with the chips a real bench would use: a TL072 for the everyday circuits, an NE5532 for the summing amp and the difference stage, and two OP07 precision op-amps where a millivolt of offset matters. The unused half of a dual is parked as a follower of ground, as it should be on a board.
Steps are graded from meters: AC volts read true RMS, DC volts the average, and a frequency counter the pitch of an oscillator. Every graded frequency is at or under a kilohertz, where the meter's AC range is trustworthy.
The lessons
- Integrator: a gain of 1 at 159 Hz, a square turned into a triangle, and the resistor that stops a 50 mV offset from pinning the output.
- Differentiator: a gain that climbs with frequency, a triangle turned into a square, and the series resistor that tames the noise.
- Summing amp: a 3-bit DAC on binary-weighted resistors, and the virtual ground that keeps the inputs apart.
- Instrumentation amp: a strain gauge bridge's 12 mV amplified while its shared 2.5 V is thrown away, and what an op-amp's offset costs.
- Precision rectifier: diodes inside the feedback loop, a full-wave absolute value, and one resistor that breaks it.
- Oscillators: a relaxation square wave and a Wien bridge sine that lives on a gain of exactly 3.
- Boss build: a strain gauge front end: hum rejection, a 2.5 V reference for a 0 to 5 V ADC, a 16 Hz low pass, and a redesign for a stiffer gauge.
Honest notes
The strain gauge is a resistor you change by hand. A real foil gauge changes by about 0.2 percent at its rated strain, so the 1 percent steps in the lessons are large on purpose, and the boss's last step uses 0.5 percent. The hum is a generator on the bridge's low end, standing in for a long sensor cable. The Wien bridge's op-amp has 1 mV of input offset set, as any real TL072 has a little, and that is what starts it oscillating.