What the course covers
Know your components is seven lessons, one chapter each, with a quiz after every chapter:
- Resistor color codes: four bands and five, gold and silver multipliers, the tolerance band, and the E12 series for an LED's resistor.
- Capacitor codes: uF, nF and pF, the three-digit code (104 is 0.1 uF), tolerance letters and electrolytic labels.
- Diodes and LEDs: the stripe on the cathode, the LED's long leg, silicon against Schottky, and why LED colors drop different volts.
- Transistor packages: TO-92 and TO-220, the 2N3904 and BC547 with mirror image pinouts, NPN against PNP, and a MOSFET in the same case.
- ICs and pin 1: the notch and the dot, counting around a DIP, powering a 555 by its pin numbers, and an LM358 whose ground is pin 4.
- Part markings: SMD codes (103, 4R7, 4701), Zener part numbers, and the conditions behind every marking.
- Boss: sort a parts bin: five unlabeled parts in testers and a 555 blinker built from the wrong drawers. Fix it, speed it up, make it yours.
How it checks your work
There is no microcontroller in the course. Every circuit is solved by the simulator, and most steps are read off a component tester: the three-socket instrument that names a part and reads its ohms, farads, forward volts or gain. You turn a code into a value in the properties panel, and the tester confirms it. Resistors draw their color bands from their value, so a right answer also shows on the part.
What the simulation is and is not
- The tester measures the simulator's model of each part. A real 2N3904 reads a different gain from the next one off the reel, and real parts sit anywhere inside their tolerance.
- LEDs read lower on the tester than on a datasheet, because the tester pushes a fraction of a milliamp and datasheets quote 20 mA.
- The simulated capacitor has no polarity. A real electrolytic fitted backwards can leak, heat and burst.
- A bare RESET pin on the simulated 555 runs; a real one floats and may not.
- Canvas parts carry no printed codes, so each step quotes the marking.
Related
Math for electronics for prefixes, Datasheets and schematics for what each pin does, and Troubleshooting like a technician for finding the part that failed.