All paths

Oscillators and timing circuits

The 555 in depth, the monostable, Schmitt and CD4060 oscillators, RC phase shift and Wien bridge sines, ending in a tone generator tuned to concert A.

Free7 lessons6 h7 chapters1,373 XPElectrical · Intermediate+150 XP

0 of 7 done

What you will build

0 projects, built step by step

7 lessons in 7 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.

The map

Chapter by chapter

Each lesson opens when the one before it is done, and each chapter ends in a project.

Chapter 1

555 astable deep

Frequency, duty, the 50 percent floor and the diode that breaks it.

  1. Open236 XP

    555 astable, in depth

    A 555 runs free at 68.6 Hz: the frequency and duty formulas, the capacitor between a third and two thirds of the supply, a tenth of the capacitor, a predicted resistor, a diode that breaks the 50 percent floor, and a slow blink.

    0 of 6 steps

4 questions, graded as you go.
Chapter 2

Monostable

One pulse per trigger: T = 1.1 RC.

  1. Locked174 XP

    Monostable: one pulse per trigger

    A 555 monostable makes one pulse of about 1.1 s per press of a button: T = 1.1 RC, a smaller capacitor for a shorter pulse, a predicted long pulse, and why monostables clean up switches and stretch short events.

    0 of 4 steps

3 questions, graded as you go.
Chapter 3

Schmitt oscillators

One gate, one resistor, one capacitor.

  1. Locked174 XP

    Schmitt oscillators: one gate, one R, one C

    A 74HC14 inverter with hysteresis and an RC around it oscillates on its own: the frequency, an uneven duty from uneven thresholds, double the capacitor, a predicted resistor, and a second gate as a buffer.

    0 of 4 steps

3 questions, graded as you go.
Chapter 4

CD4060 dividers

An RC oscillator and fourteen halvings.

  1. Locked205 XP

    CD4060 dividers: slow and steady from fast

    A CD4060's RC oscillator at 4.5 kHz and its binary dividers: Q4 at a sixteenth, Q7 at a 128th, a predicted capacitor, and how a one-minute timer comes out of fourteen flip-flops.

    0 of 5 steps

3 questions, graded as you go.
Chapter 5

RC phase shift

Three stages, 180 degrees and a gain of 29.

  1. Locked174 XP

    RC phase shift: three stages and a gain of 29

    An LM358 inverting amplifier fed back through three RC stages: 650 Hz from the formula, the size of the wave, twice the capacitors, and a predicted retune.

    0 of 4 steps

3 questions, graded as you go.
Chapter 6

Wien bridge

A gain of 3 on one supply.

  1. Locked174 XP

    Wien bridge on one supply

    The Wien bridge from the op-amp cookbook, rebuilt on an LM358 from one 9 V supply: a 4.5 V bias, 1592 Hz from 1 / (2 pi RC), the sine's size, both capacitors retuned together, and a predicted resistor pair.

    0 of 4 steps

3 questions, graded as you go.
Chapter 7

Boss build

A divided 555 tuned to 440 Hz.

  1. Locked236 XP

    Boss: a steady tone generator

    A 555 at about 7 kHz clocks a CD4060 that divides it by 16 into an LM358 buffer and a piezo: wire the clock, read both counters, tune the 555 to concert A at 440 Hz, then drop it an octave.

    0 of 6 steps

3 questions, graded as you go.
Syllabus

Every lesson in the course

All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.

Chapter 1

555 astable deep

  1. 555 astable, in depthA 555 runs free at 68.6 Hz: the frequency and duty formulas, the capacitor between a third and two thirds of the supply, a tenth of the capacitor, a predicted resistor, a diode that breaks the 50 percent floor, and a slow blink.
Chapter 2

Monostable

  1. Monostable: one pulse per triggerA 555 monostable makes one pulse of about 1.1 s per press of a button: T = 1.1 RC, a smaller capacitor for a shorter pulse, a predicted long pulse, and why monostables clean up switches and stretch short events.
Chapter 3

Schmitt oscillators

  1. Schmitt oscillators: one gate, one R, one CA 74HC14 inverter with hysteresis and an RC around it oscillates on its own: the frequency, an uneven duty from uneven thresholds, double the capacitor, a predicted resistor, and a second gate as a buffer.
Chapter 4

CD4060 dividers

  1. CD4060 dividers: slow and steady from fastA CD4060's RC oscillator at 4.5 kHz and its binary dividers: Q4 at a sixteenth, Q7 at a 128th, a predicted capacitor, and how a one-minute timer comes out of fourteen flip-flops.
Chapter 5

RC phase shift

  1. RC phase shift: three stages and a gain of 29An LM358 inverting amplifier fed back through three RC stages: 650 Hz from the formula, the size of the wave, twice the capacitors, and a predicted retune.
Chapter 6

Wien bridge

  1. Wien bridge on one supplyThe Wien bridge from the op-amp cookbook, rebuilt on an LM358 from one 9 V supply: a 4.5 V bias, 1592 Hz from 1 / (2 pi RC), the sine's size, both capacitors retuned together, and a predicted resistor pair.
Chapter 7

Boss build

  1. Boss: a steady tone generatorA 555 at about 7 kHz clocks a CD4060 that divides it by 16 into an LM358 buffer and a piezo: wire the clock, read both counters, tune the 555 to concert A at 440 Hz, then drop it an octave.
Kits

Build it on your bench too

Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.

Have a kit already?

Find your kit

Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.

See every kit
Questions

About Oscillators and timing circuits

Is Oscillators and timing circuits free?

Yes. All 7 lessons of Oscillators and timing circuits are free and run in your browser, with nothing to install and no parts to buy before you start.

Do I need any parts?

No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.

How long does Oscillators and timing circuits take?

About 6 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.

Where do I start?

With "555 astable, in depth", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.