Üstlen /learn olarak Osilatörler ve zamanlama devreleri.
Dersler
- 555 astable deep: frequency and duty formulas, a capacitor between a third and two thirds of the supply, and a diode that breaks the 50 percent floor.
- Monostable: her basışta bir kez 1.1 s'lik darbe, T = 1.1 RC.
- Schmitt osilatörleri: bir direnç ve bir kondansatörlü bir 74HC14 kapısı ve tampon olarak ikinci bir kapı.
- CD4060 bölücüler: bir RC osilatör ve on dört kez yarıya indirme, bir dakikalık zamanlayıcıya kadar.
- RC faz kaydırma: üç RC kademesinden geri beslenen, en az 29 kazançlı bir LM358 evirici.
- Wien köprüsü: operasyonel amplifikatör kitabındaki Wien köprüsü, tek bir 9 V besleme ile.
- Patron: kararlı bir ton üreteci: bir 555, bir CD4060'ı saatler, o da 16'ya bölerek bir LM358 takipçiye ve bir piezoya gider. 440 Hz'e akort et, sonra bir oktav düşür.
Nasıl ölçülür
Every circuit runs with no microcontroller. A frequency counter reads each oscillator, a multimeter reads duty or AC volts, and a scope shows the waveforms. The LM358s have 1 mV of input offset set, as a real one has a few, which is what starts the sine oscillators.
Modellerin sınırları
Real 555s and RC oscillators drift with temperature and their capacitors are often 10 to 20 percent off their labels, so tune with a counter. The CD4060's Schmitt input and protection diodes are not modeled. For timing you can trust, use a crystal.