Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitPick up any part and know what it is: resistor bands, capacitor codes, diodes and LEDs, transistor packages, pin 1 on a chip, SMD markings, and a mixed parts bin sorted into a working blinker.
0 of 7 done
7 lessons in 7 chapters, about 5 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Four bands, five bands, gold multipliers and the E12 series.
Read four-band and five-band resistors, the gold and silver multipliers, the tolerance band, and pick a real value for an LED, with a component tester checking every answer.
0 of 6 steps
uF, nF and pF, the three-digit code, tolerance letters and electrolytics.
Microfarads, nanofarads and picofarads, the three-digit code on ceramic caps, tolerance letters, electrolytic labels, and what to do when a part is too small for the tester.
0 of 5 steps
Stripes, long legs, forward volts and the LED's resistor.
Find the cathode by its stripe and an LED by its short leg, read forward voltage on a tester, tell silicon from Schottky, see why LED colors drop different volts, and set an LED's current.
0 of 6 steps
TO-92 and TO-220, mirror pinouts, NPN, PNP and MOSFETs.
TO-92 and TO-220, why the same shape hides different pinouts, NPN against PNP, a MOSFET in a transistor's clothes, and a transistor switching an LED.
0 of 6 steps
The notch and the dot, counting pins, and a datasheet for every chip.
Find pin 1 by the notch and the dot, count around a DIP, power a 555 by its pin numbers, change its rate with a capacitor code, and learn why every chip needs its own datasheet.
0 of 7 steps
SMD codes, Zener numbers and diodes in mixed bags.
Surface-mount resistor codes (103, 4R7, 4701), Zener part numbers that state their voltage, glass and black diodes by number, and how to read what little a tiny part says.
0 of 7 steps
Sort a bin, fix a blinker, make it yours.
Five unlabeled parts in five testers and a 555 blinker built from the wrong drawers: identify the bin, fix the transistor, the timing cap and the LED resistor, then make it blink faster in your own color.
0 of 6 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of Know your components are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 5 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Resistor color codes", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.