Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitSolve resistor networks on paper and prove them on the meters: KVL, KCL, series-parallel reduction, Thevenin, Norton, superposition, maximum power, and a Wheatstone bridge you turn into a sensor.
0 of 8 done
8 lessons in 8 chapters, about 6 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Every loop adds to zero, with one source or two.
Kirchhoff's voltage law on a real loop: rises equal drops, any path between two points gives the same voltage, two sources aiding and opposing, and a resistor chosen so a drop lands on a target.
0 of 6 steps
What goes into a node comes out, and a resistor solved from it.
Kirchhoff's current law at a node: an ammeter in the supply lead, branch currents read off each resistor, a new branch wired in, and a resistor solved so the supply draws a set current.
0 of 6 steps
Collapse a network to one resistor, and an R-2R ladder.
Collapse a network to one resistor on an ohmmeter: series adds, parallel is product over sum, equal parts halve, then an R-2R ladder that halves the voltage at every node.
0 of 6 steps
Voc, Isc and Rth, measured, built and proven.
Measure a network's open-circuit voltage, short-circuit current and resistance with the sources off, build its Thevenin equivalent, and prove the two give the same answer under any load.
0 of 6 steps
A current source, source transformation and compliance.
The same network as a current source in parallel with a resistor: a bench supply in constant-current mode as the source, source transformation back to Thevenin, and what compliance voltage means.
0 of 6 steps
One source at a time, and why power does not add.
Two sources feeding one node: switch each off in turn, add the answers, predict a doubled and a reversed source by scaling, and see why power does not add the same way.
0 of 6 steps
The matched load, and the efficiency it costs.
Sweep a load across a source with internal resistance, find the peak where the load matches it, see the 50 percent efficiency that comes with it, and match a load to a real network's Thevenin resistance.
0 of 5 steps
Solve, verify, balance and sense with a Wheatstone bridge.
A Wheatstone bridge solved on paper and proven on the meters: its output by two dividers, its Thevenin resistance with the source off, the current in a detector, then balance it and turn it into a sensor.
0 of 6 steps
All 8 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 8 lessons of DC circuit analysis are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 6 hours: 8 lessons in 8 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "KVL: every loop adds to zero", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.