Pods talking
Link a wireless pod with nRF24L01 radios: the hub tells pod C to light, pod C times the touch on its own clock and radios the result back.
Open it in the simulatorTouch pads, LED rings and a wireless pod on nRF24L01: random drills timed to the millisecond, scores and a record that survives the night.
0 of 6 done
6 lessons in 2 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Link a wireless pod with nRF24L01 radios: the hub tells pod C to light, pod C times the touch on its own clock and radios the result back.
Open it in the simulatorRun real training sessions on the three pods, see what a session of misses scores, then make the drills your own and build pods for a gym.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Touch pads, colors and a pod that talks by radio.
Read TTP223 touch pads that feel a finger through plastic, with their half-second start and 60 ms answer, and light each pod's ring under a finger.
0 of 5 steps
Make the rings speak in colors: dim blue for waiting, green for go, red for a miss, with a touch on the green pod putting it out.
0 of 4 steps
Link a wireless pod with nRF24L01 radios: the hub tells pod C to light, pod C times the touch on its own clock and radios the result back.
0 of 5 steps
Random drills, fair scores and a full training session.
Run a drill of ten lights in random order after random gaps across all three pods, and time every reaction to the millisecond.
0 of 5 steps
Score a drill fairly: hits, misses counted as the full timeout, the average and the best reaction, a rating, and a record kept in EEPROM.
0 of 4 steps
Run real training sessions on the three pods, see what a session of misses scores, then make the drills your own and build pods for a gym.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build reaction training pods is part of the maker track, a ladder of courses from zero to expert.
Drive a thermal receipt printer from an Uno: ESC/POS bytes, 1-bit bitmaps, a fortune button, a to-do list, ASCII art and a daily brief.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An Uno, a touch sensor (TTP223), addressable RGB LEDs and a 2.4 GHz radio (nRF24L01+): three pods that test and time your reactions.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build reaction training pods are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Pods talking and Project: a training session.
With "Touch pads", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.