Projects with a photoresistor
17 Mokxi projects use a photoresistor (8 beginner, 7 intermediate and 2 advanced). They run on Arduino Uno and Raspberry Pi Pico boards, and 2 need no board at all. Here are all of them, from “Pico W photoresistor divider on GP28” to “Solar tracker”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.
How to pick your first one
- Start with “Pico W photoresistor divider on GP28”, a beginner project that needs a resistor and a photoresistor.
- Arduino Uno runs 11 of them, Raspberry Pi Pico 3 and 2 need no board at all. Start on the board you have, or on an Arduino Uno if you are buying one.
- The parts used most here are the LED (12 projects), the potentiometer (4) and the push button (3). With those on hand, most of this list is open to you.
- Before you build one on a real bench, read the photoresistor wiring guide for your board below. It gives every pin and the voltage notes.
17 projects ready to run

Pico W photoresistor divider on GP28
MicroPython on a Pico W: a photoresistor and a 10k divide 3.3 V with the middle on GP28, and ADC(28) prints the light level twice a second.
- Board
- Raspberry Pi Pico W
- Parts
- Resistor, photoresistor
- Level
- Beginner

Dinosaur game player: light sensor on A0, servo on 9
A photoresistor on A0 watches the screen of the browser’s dinosaur game; when a dark cactus passes over it.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, servo motor
- Level
- Beginner

Photoresistor night light: A0 dims the LED on pin 9
A photoresistor and a 10k resistor in a divider on A0 set the brightness of an LED on pin 9: the darker the room, the brighter the LED.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, LED
- Level
- Beginner

MicroPython night lamp: a photoresistor dims an LED
MicroPython on an ESP32: a photoresistor and a 10k on GPIO 36 set the LED on GPIO 25, which glows brighter as the room gets darker.
- Board
- ESP32-DevKitC V4
- Parts
- Resistor, photoresistor, LED
- Level
- Beginner

Light meter: photoresistor on A0, LEDs on pins 5 to 12
A photoresistor and a 10k resistor on A0 set how many of eight LEDs on pins 5 to 12 light: none in the dark, all of them in bright light.
- Board
- Arduino Uno R3
- Parts
- Resistor, LED, photoresistor
- Level
- Beginner

Night light with a light sensor
A light-dependent resistor in a divider fades a lamp up when the room goes dark. Drag the slider on the sensor.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, LED
- Level
- Beginner

MicroPython night lamp on a Pico: light sensor on GP26
MicroPython on a Raspberry Pi Pico: a photoresistor and a 10k on GP26 set the LED on GP15, so the darker it gets, the brighter the LED.
- Board
- Raspberry Pi Pico
- Parts
- Resistor, photoresistor, LED
- Level
- Beginner

Rescue beacon
A white LED flashes SOS from a table of lengths, but only in the dark: a light sensor wakes it at dusk and a button forces it on.
- Board
- Arduino Uno R3
- Parts
- Resistor, LED, push button, photoresistor
- Level
- Beginner

LM393 night light with a ULN2003A
An LM393 compares an LDR with a knob, its open-collector output pulled up by 10 k.
- Board
- No board
- Parts
- Photoresistor, resistor, potentiometer, LM393 dual comparator, ULN2003A Darlington array, +1 more
- Level
- Intermediate

Photocell light meter
A photocell and a 10k resistor on A0 set how many of eight LEDs a 74HC595 lights: none in the dark, all eight in bright light.
- Board
- Arduino Uno R3
- Parts
- 74HC595 shift register, resistor, LED, photoresistor
- Level
- Intermediate

Dark detector
An op-amp comparator, an LDR and a pot light an LED when the room goes dark, no board, on a half-size breadboard.
- Board
- No board
- Parts
- Photoresistor, resistor, potentiometer, op-amp, LED
- Level
- Intermediate

Automatic curtain opener with a stepper motor
A NEMA 17 on an A4988 homes to an end switch, opens the curtain at dawn and closes it at dusk, with a button to open, close or stop and a speed knob.
- Board
- Arduino Uno R3
- Parts
- A4988 stepper driver, NEMA 17 stepper motor, DC jack and adapter, capacitor, limit switch, +4 more
- Level
- Intermediate

Pico W light theremin: light sets the pitch
MicroPython on a Pico W: a photoresistor on GP28 learns its range for five seconds, then the light level sets a passive buzzer’s pitch on GP15.
- Board
- Raspberry Pi Pico W
- Parts
- Piezo speaker, transistor, resistor, photoresistor, LED
- Level
- Intermediate

LM358 dark switch with an Arduino
An LM358 comparator lights an LED when the LDR goes dark, past a threshold set by a knob.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, potentiometer, LM358 dual op-amp, LED
- Level
- Intermediate

Photocell bar graph on a 74HC595
A photocell and a 1k resistor on A0 set how many of eight LEDs a 74HC595 lights, with data on pin 12, clock on 9 and latch on 11.
- Board
- Arduino Uno R3
- Parts
- 74HC595 shift register, resistor, LED, photoresistor
- Level
- Intermediate

Plant monitor: light, soil, temperature and a pump
A photoresistor on A0, a soil moisture sensor on A1 and a thermistor on A2 report to an I2C LCD; when the soil dries out.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, 10k NTC thermistor, L293D motor driver, capacitive soil moisture sensor, +2 more
- Level
- Advanced

Solar tracker
Four light sensors steer a pan and tilt servo pair, an INA219 measures the panel, and the sketch alternates tracked and fixed windows.
- Board
- Arduino Uno R3
- Parts
- Photoresistor, resistor, servo motor, INA219 current monitor, solar panel, +2 more
- Level
- Advanced
Wiring, libraries and more ideas
Wiring guides
More project ideas
- Arduino Uno project ideas
- Raspberry Pi Pico project ideas
- Electronics projects with no code
- ESP32 project ideas
- LED projects for Arduino, ESP32 and Pico
- Projects with a potentiometer
- Projects with a push button
- Projects with a 74HC595 shift register
- Servo motor projects
- Projects with an A4988 stepper driver
- Projects with a capacitor