Project ideas by board

Arduino Mega project ideas

11 Mokxi projects run on an Arduino Mega 2560 (2 beginner, 3 intermediate and 6 advanced). Here are all of them, from “Mega four serial ports” to “GPS logger”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Robotic hand with flex sensors”, a beginner project that needs a servo motor and a flex sensor.
  • Most of them are advanced projects. Pick one a level below what you think you can do, finish it, then move up.
  • The parts used most here are the piezo speaker (5 projects), the arcade button (3) and the servo motor (3). With those on hand, most of this list is open to you.
  • Reach for the Mega when a build runs out of pins or serial ports on an Uno. It has 54 digital pins and four hardware serial ports.
Projects

11 projects ready to run

  • Mega four serial ports, drawn in the Mokxi editor

    Mega four serial ports

    Three of the Mega's four USARTs, each with its TX jumpered back to its own RX, reporting on the fourth.

    Board
    Arduino Mega 2560 R3
    Parts
    Just the board
    Level
    Beginner
    Open in the simulator
  • Robotic hand with flex sensors, drawn in the Mokxi editor

    Robotic hand with flex sensors

    Robotic hand with flex sensors on an Arduino Mega: five flex sensors on a glove move five servo fingers, and the Serial Monitor names the gesture.

    Board
    Arduino Mega 2560 R3
    Parts
    Servo motor, flex sensor
    Level
    Beginner
    Open in the simulator
  • Grove OLED, drawn in the Mokxi editor

    Grove OLED

    The 1.12 inch 128x128 SH1107 OLED with Adafruit’s SH110X library on a Mega: a ball bounces around the square, sent as sixteen pages of RAM.

    Board
    Arduino Mega 2560 R3
    Parts
    OLED display
    Level
    Intermediate
    Open in the simulator
  • Tilt compass, drawn in the Mokxi editor

    Tilt compass

    An MPU-9250 on a Mega reads which way is down and which way is north: the accelerometer and the AK8963 compass through the bypass.

    Board
    Arduino Mega 2560 R3
    Parts
    Nine-axis IMU
    Level
    Intermediate
    Open in the simulator
  • LD2410 presence radar, drawn in the Mokxi editor

    LD2410 presence radar

    A Hi-Link LD2410 mmWave radar on the Mega’s Serial1 at 256000 baud: the ld2410 library tells a moving person from a still one, and OUT lights the LED.

    Board
    Arduino Mega 2560 R3
    Parts
    Presence radar
    Level
    Intermediate
    Open in the simulator
  • Escape-room puzzle box, drawn in the Mokxi editor

    Escape-room puzzle box

    Five puzzles in ten minutes: a keypad code, a magnet key, the right RFID card, a tilt sequence and three flashes of light.

    Board
    Arduino Mega 2560 R3
    Parts
    4x4 keypad, reed switch, piezo speaker, MPU6050 accelerometer and gyro, servo motor, +6 more
    Level
    Advanced
    Open in the simulator
  • Pinball table, drawn in the Mokxi editor

    Pinball table

    A table you can play on a Mega: flippers, pop bumpers on a kicker solenoid, targets, a drain beam and a plunger, with a four-digit score.

    Board
    Arduino Mega 2560 R3
    Parts
    TM1637 four-digit display, WS2812 NeoPixel LEDs, pinball table, MOSFET, diode, +3 more
    Level
    Advanced
    Open in the simulator
  • Spaceship control panel, drawn in the Mokxi editor

    Spaceship control panel

    Arm three systems, pass the go/no-go poll, lift the safety and launch.

    Board
    Arduino Mega 2560 R3
    Parts
    Slide switch, LED arcade button, TM1637 four-digit display, piezo speaker, WS2812 NeoPixel LEDs, +7 more
    Level
    Advanced
    Open in the simulator
  • Breakout game on an OLED, drawn in the Mokxi editor

    Breakout game on an OLED

    Breakout game on an OLED with a knob for the paddle: 32 bricks, three lives, a faster ball for every wall you clear, and sound on a piezo.

    Board
    Arduino Mega 2560 R3
    Parts
    SSD1306 OLED display, arcade button, piezo speaker, potentiometer
    Level
    Advanced
    Open in the simulator
  • Tetris on LED matrices, drawn in the Mokxi editor

    Tetris on LED matrices

    Tetris on LED matrices with an Arduino Mega: two 8x8 MAX7219s make an 8 by 16 field, with four buttons, all seven pieces.

    Board
    Arduino Mega 2560 R3
    Parts
    MAX7219 8x8 LED matrix, arcade button, piezo speaker
    Level
    Advanced
    Open in the simulator
  • GPS logger, drawn in the Mokxi editor

    GPS logger

    A NEO-6M on the Mega’s second serial port and a microSD card: every position goes into TRACK.CSV, which you can watch grow and download.

    Board
    Arduino Mega 2560 R3
    Parts
    GPS module, microSD card module
    Level
    Advanced
    Open in the simulator