Project ideas by part

Projects with a soil moisture sensor

6 Mokxi projects use a capacitive soil moisture sensor (2 beginner, 2 intermediate and 2 advanced). They run on Arduino Uno and ESP32 boards. Here are all of them, from “Mini pump plant waterer” to “Plant monitor: light, soil, temperature and a pump”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Mini pump plant waterer”, a beginner project that needs a soil moisture sensor, a relay module and a water pump.
  • Arduino Uno runs 5 of them and ESP32 1. Start on the board you have, or on an Arduino Uno if you are buying one.
  • The parts used most here are the I2C LCD (2 projects), the photoresistor module (2) and the LED (2). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, read the capacitive soil moisture sensor wiring guide for your board below. It gives every pin and the voltage notes.
Projects

6 projects ready to run

  • Mini pump plant waterer, drawn in the Mokxi editor

    Mini pump plant waterer

    A capacitive soil probe watches the pot; when it reads dry, a relay runs the mini pump for three seconds, then waits for the water to soak in.

    Board
    Arduino Uno R3
    Parts
    Capacitive soil moisture sensor, relay module, mini water pump
    Level
    Beginner
    Open in the simulator
  • Plant sensor for Home Assistant, drawn in the Mokxi editor

    Plant sensor for Home Assistant

    A capacitive soil sensor mapped between two calibration readings, a light level, and a thirsty LED with two thresholds so it does not flicker.

    Board
    ESP32-C3-DevKitM-1
    Parts
    Photoresistor module, capacitive soil moisture sensor, resistor, LED
    Level
    Beginner
    Open in the simulator
  • Automatic plant waterer, drawn in the Mokxi editor

    Automatic plant waterer

    A soil moisture stake, a relay and a small pump water a plant when it gets dry, in short bursts with time to soak.

    Board
    Arduino Uno R3
    Parts
    Capacitive soil moisture sensor, water level sensor, push button, relay module, DC motor, +2 more
    Level
    Intermediate
    Open in the simulator
  • Plant monitor, drawn in the Mokxi editor

    Plant monitor

    A soil moisture sensor, a rain sensor and a water level sensor on three analog pins. Two read lower when wetter and one reads higher.

    Board
    Arduino Uno R3
    Parts
    Capacitive soil moisture sensor, rain sensor, water level sensor, resistor, LED
    Level
    Intermediate
    Open in the simulator
  • Mars rover, drawn in the Mokxi editor

    Mars rover

    A rover that drives three waypoints by dead reckoning, steers around hazards it sees with a sonar mast, samples soil and light.

    Board
    Arduino Uno R3
    Parts
    L298N motor driver, 2WD robot car chassis, push button, SSD1306 OLED display, VL53L0X time-of-flight sensor, +3 more
    Level
    Advanced
    Open in the simulator
  • Plant monitor: light, soil, temperature and a pump, drawn in the Mokxi editor

    Plant monitor: light, soil, temperature and a pump

    A photoresistor on A0, a soil moisture sensor on A1 and a thermistor on A2 report to an I2C LCD; when the soil dries out.

    Board
    Arduino Uno R3
    Parts
    Photoresistor, resistor, 10k NTC thermistor, L293D motor driver, capacitive soil moisture sensor, +2 more
    Level
    Advanced
    Open in the simulator