Project ideas by part

Projects with a water level sensor

4 Mokxi projects use a water level sensor (2 beginner and 2 intermediate). They run on Arduino Uno and Raspberry Pi Pico boards. Here are all of them, from “Pico W water level sensor on GP28” to “Plant monitor”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Pico W water level sensor on GP28”, a beginner project that needs a water level sensor.
  • Arduino Uno runs 3 of them and Raspberry Pi Pico 1. Start on the board you have, or on an Arduino Uno if you are buying one.
  • The parts used most here are the capacitive soil moisture sensor (2 projects), the DC motor (1) and the I2C LCD (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the water level sensor part page for its pins and what each one does.
Projects

4 projects ready to run

  • Pico W water level sensor on GP28, drawn in the Mokxi editor

    Pico W water level sensor on GP28

    MicroPython on a Pico W: a water level sensor on GP28 reads higher as more of it is wet, and over 30000 the program warns of a leak.

    Board
    Raspberry Pi Pico W
    Parts
    Water level sensor
    Level
    Beginner
    Open in the simulator
  • Water level sensor, drawn in the Mokxi editor

    Water level sensor

    A water level sensor on A0: the sketch sorts the reading into dry, low, half and full and prints each change.

    Board
    Arduino Uno R3
    Parts
    Water level sensor
    Level
    Beginner
    Open in the simulator
  • Automatic plant waterer, drawn in the Mokxi editor

    Automatic plant waterer

    A soil moisture stake, a relay and a small pump water a plant when it gets dry, in short bursts with time to soak.

    Board
    Arduino Uno R3
    Parts
    Capacitive soil moisture sensor, water level sensor, push button, relay module, DC motor, +2 more
    Level
    Intermediate
    Open in the simulator
  • Plant monitor, drawn in the Mokxi editor

    Plant monitor

    A soil moisture sensor, a rain sensor and a water level sensor on three analog pins. Two read lower when wetter and one reads higher.

    Board
    Arduino Uno R3
    Parts
    Capacitive soil moisture sensor, rain sensor, water level sensor, resistor, LED
    Level
    Intermediate
    Open in the simulator