Where a ripple counter (two 74HC74s) lets the carry walk from stage to stage, the 161 clocks all four flip-flops together, so you can read it at any moment without catching a half-counted number. Aliases: 74161, SN74HC161, CD74HC161, synchronous binary counter, presettable counter.
Pins
| Pin | Nama | Fungsinya |
|---|---|---|
| 2 | CP |
Clock. Semua yang terjadi, terjadi pada sisi naik (rising edge). |
| 14, 13, 12, 11 | Q0 sampai Q3 |
The count, Q0 the 1s bit. |
| 3 sampai 6 | D0 sampai D3 |
Angka yang dimasukkan oleh load. |
| 9 | PE |
Enable paralel (load), aktif low. Low: clock berikutnya memuat D0 sampai D3. |
| 7 | CEP |
Enable hitung. |
| 10 | CET |
Enable hitung yang juga meng-gate TC. |
| 15 | TC |
Terminal count: high saat hitungan bernilai 15 dan CET high. |
| 1 | MR |
Master reset, aktif low. Low langsung mengosongkan hitungan. |
| 8 | GND |
Ground. |
| 16 | VCC |
Pasokan, 2 V sampai 6 V. |
Tabel kebenaran
MR |
PE |
CEP |
CET |
CP |
Apa yang terjadi |
|---|---|---|---|---|---|
| 0 | x | x | x | x | Clear to 0 (no clock needed) |
| 1 | 0 | x | x | sisi naik | Memuat D0 sampai D3 |
| 1 | 1 | 1 | 1 | sisi naik | Hitung naik (15 kembali ke 0) |
| 1 | 1 | 0 | x | x | Tahan |
| 1 | 1 | x | 0 | x | Tahan |
Two 161s make an 8-bit counter: share the clock, and wire the first chip's TC to the
second chip's CEP and CET.
Properti
Tidak ada.
Apa yang modelnya dapat dengan benar
The reset is asynchronous and the load is synchronous, which is the one difference
between the 161 and its sibling the 163 (whose reset waits for the clock too). All four
outputs move one delay after the clock edge, together. Delays are the CD74HC161
typicals at 5 V and 15 pF: 15 ns from the clock to the count and to TC, 18 ns from
MR, and 9 ns from CET to TC.
Apa yang tidak dimodelkannya
Tidak ada waktu setup atau hold terhadap clock, dan satu waktu tunda per jalur. Saat dinyalakan nilainya 0. Enable yang tidak bisa dibaca (mengambang) pada sisi clock membuat hitungan tidak diketahui.
Common mistakes
Mengira PE low akan langsung memuat: padahal ia menunggu clock berikutnya. Membiarkan CEP atau CET mengambang, yang membuat hitungan tidak bisa diketahui; sambungkan keduanya ke VCC agar menghitung.
Lihat aksinya
Penari decoder memberi clock pada sebuah 161 dari osilator 74HC14 dan mendekode hitungannya dengan 74HC138. Buka di /templates.