Project ideas by part

Projects with a hall effect sensor

4 Mokxi projects use a hall effect sensor (1 beginner and 3 advanced). They run on Pro Micro and Arduino Uno boards. Here are all of them, from “Pocket gaussmeter” to “H-pattern shifter and handbrake”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Pocket gaussmeter”, a beginner project that needs a hall effect sensor and an I2C LCD.
  • Pro Micro runs 3 of them and Arduino Uno 1. Start on the board you have, or on a Pro Micro if you are buying one.
  • The parts used most here are the potentiometer (2 projects), the arcade button (1) and the game console buttons (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the 49E linear hall sensor part page for its pins and what each one does.
Projects

4 projects ready to run

  • Pocket gaussmeter, drawn in the Mokxi editor

    Pocket gaussmeter

    A 49E linear Hall sensor on A0 and a 16x2 I2C LCD: the field in gauss, which pole it is, and the strongest seen since power on.

    Board
    Arduino Uno R3
    Parts
    49E linear hall sensor, I2C LCD
    Level
    Beginner
    Open in the simulator
  • Load cell pedals on a Pro Micro, drawn in the Mokxi editor

    Load cell pedals on a Pro Micro

    A load cell brake on an HX711 that responds to force, a hall sensor throttle and a pot clutch, each calibrated and sent as one Joystick.h report.

    Board
    SparkFun Pro Micro
    Parts
    Load cell with HX711, 49E linear hall sensor, potentiometer
    Level
    Advanced
    Open in the simulator
  • Flight stick and throttle on a Pro Micro, drawn in the Mokxi editor

    Flight stick and throttle on a Pro Micro

    A two-axis stick with a center deadzone and an expo curve, a twist rudder, a hall sensor throttle, a hat switch and two buttons.

    Board
    SparkFun Pro Micro
    Parts
    Game console buttons, 49E linear hall sensor, potentiometer, joystick
    Level
    Advanced
    Open in the simulator
  • H-pattern shifter and handbrake, drawn in the Mokxi editor

    H-pattern shifter and handbrake

    Two pots read an H-pattern gate with hysteresis and push-down reverse, two microswitches make sequential paddles and a hall sensor is the handbrake.

    Board
    SparkFun Pro Micro
    Parts
    TM1637 four-digit display, limit switch, slide potentiometer, arcade button, 49E linear hall sensor
    Level
    Advanced
    Open in the simulator