Project ideas by part

Projects with an MQ-2 gas sensor

4 Mokxi projects use an MQ-2 gas sensor (3 beginner and 1 intermediate). They run on Arduino Uno and Raspberry Pi boards, and 1 needs no board at all. Here are all of them, from “Gas leak detector with an MQ-2” to “MQ-2 gas sensor on a Pi with an MCP3008”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Gas sensor module on A0”, a beginner project that needs an MQ-2 gas sensor.
  • Arduino Uno runs 2 of them, Raspberry Pi 1 and 1 needs no board at all. Start on the board you have, or on an Arduino Uno if you are buying one.
  • The parts used most here are the LED (2 projects), the buzzer (1) and the FC-51 IR obstacle sensor (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the MQ-2 gas sensor part page for its pins and what each one does.
Projects

4 projects ready to run

  • Gas leak detector with an MQ-2, drawn in the Mokxi editor

    Gas leak detector with an MQ-2

    An MQ-2 on A0 waits out its warm-up, then shows the gas level on a 16x2 I2C LCD and a traffic light, and a buzzer beeps when LPG passes the limit.

    Board
    Arduino Uno R3
    Parts
    Traffic light module, buzzer, MQ-2 gas sensor, I2C LCD
    Level
    Beginner
    Open in the simulator
  • Gas sensor module on A0, drawn in the Mokxi editor

    Gas sensor module on A0

    An MQ-2 gas sensor’s analog output on A0, printed twice a second: the more gas, the higher the reading. The heater takes a while to warm up first.

    Board
    Arduino Uno R3
    Parts
    MQ-2 gas sensor
    Level
    Beginner
    Open in the simulator
  • Comparator boards, drawn in the Mokxi editor

    Comparator boards

    An MQ-2, a flame sensor, a TCRT5000 and an FC-51, each lighting a lamp from DO with no board. The same LM393 under four sensors, and DO goes low.

    Board
    No board
    Parts
    MQ-2 gas sensor, flame sensor, TCRT5000 line sensor, FC-51 IR obstacle sensor, LED, +1 more
    Level
    Beginner
    Open in the simulator
  • MQ-2 gas sensor on a Pi with an MCP3008, drawn in the Mokxi editor

    MQ-2 gas sensor on a Pi with an MCP3008

    An MQ-2 on a Raspberry Pi 5: its 5 V output divided down to 3.3 V, read through an MCP3008 with gpiozero.

    Board
    Raspberry Pi 5
    Parts
    Eight-channel ADC, MQ-2 gas sensor, resistor, LED
    Level
    Intermediate
    Open in the simulator