Componentes

Acelerómetro LSM6DSOX y giroscopio

La IMU de seis ejes ST LSM6DSOX lee la aceleración y la velocidad de giro, dieciséis bits cada una, por I2C en 0x6A, de 12.5 Hz a 6.66 kHz.

This part has a page of its own, with a note on using it and a circuit to try: the part page.

Alias: LSM6DS, LSM6DS33, LSM6DSO, Adafruit LSM6DSOX, IMU de seis ejes. Es el sensor de movimiento de las placas más recientes de Adafruit y Arduino: menos ruido que el MPU6050 y un núcleo de aprendizaje automático propio, que el modelo omite.

Pins

Pin Qué hace
VIN, GND Alimentación, de 3 a 5 V en la placa.
SCL, SDA I2C. La placa incluye las resistencias pull-up.
INT1, INT2 Interrupciones, dejadas en alta impedancia por el modelo.

Propiedades

address es 0x6A o 0x6B. pitch, roll y heading indican cómo está colocada la placa; los tres deslizadores la inclinan y giran, y el giroscopio lee la velocidad mientras se mueve un deslizador.

Leerlo en un Arduino

Con la biblioteca de Adafruit, que Mokxi incluye como Adafruit_LSM6DSOX.h:

#include <Adafruit_LSM6DSOX.h>
Adafruit_LSM6DSOX sox;

void setup() {
  Serial.begin(9600);
  sox.begin_I2C();
}

void loop() {
  sensors_event_t accel, gyro, temp;
  sox.getEvent(&accel, &gyro, &temp);
  Serial.println(accel.acceleration.z);   // 9.81 flat on the bench
  delay(200);
}

Cómo se comunica

WHO_AM_I (0x0F) reads 0x6C. CTRL1_XL (0x10) and CTRL2_G (0x11) set each sensor's data rate (zero is off, the reset) and range; CTRL3_C (0x12) has the reset bits and IF_INC, which steps the address. At each sample STATUS_REG (0x1E) flags new data, and the outputs follow: the temperature at 0x20, the gyroscope at 0x22 and the accelerometer at 0x28, low byte first. For 10 ms after power-on it boots and does not answer.

Lo que no modela

El FIFO, las funciones integradas (podómetro, toque, inclinación, el núcleo de aprendizaje automático), los pines de interrupción, filtros, ruido y offsets.

Common mistakes

Reading zeros: both sensors power up off until a data rate is written. Reading a gyroscope that never moves: it reads a rate, so it is zero whenever the board is still.