Project ideas by part

Projects with a float switch

5 Mokxi projects use a float switch (1 beginner, 3 intermediate and 1 advanced). They run on Arduino Uno boards. Here are all of them, from “Sump alarm” to “Delta-T monitor”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Sump alarm”, a beginner project that needs a float switch, a buzzer, a resistor and 1 more part.
  • All of them run on an Arduino Uno, so that is the one board you need.
  • The parts used most here are the LED (4 projects), the push button (3) and the relay module (3). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the float switch part page for its pins and what each one does.
Projects

5 projects ready to run

  • Sump alarm, drawn in the Mokxi editor

    Sump alarm

    A float switch in the sump on an Uno: when the water lifts the float, a buzzer sounds a siren and a red LED lights until the water has gone back down.

    Board
    Arduino Uno R3
    Parts
    Float switch, buzzer, resistor, LED
    Level
    Beginner
    Open in the simulator
  • Water level controller with float switches, drawn in the Mokxi editor

    Water level controller with float switches

    Two float switches keep a tank between its low and high marks with a pump on a relay; a stuck float or a pump running dry stops it and blinks red.

    Board
    Arduino Uno R3
    Parts
    Float switch, push button, resistor, LED, relay module, +2 more
    Level
    Intermediate
    Open in the simulator
  • Bottling line, drawn in the Mokxi editor

    Bottling line

    A belt brings each bottle to the filler, a pump fills it until the float switch trips, and the LCD counts them.

    Board
    Arduino Uno R3
    Parts
    Two-channel relay board, DC motor, mini water pump, FC-51 IR obstacle sensor, float switch, +4 more
    Level
    Intermediate
    Open in the simulator
  • Sump pump controller, drawn in the Mokxi editor

    Sump pump controller

    A teaching model of a sump controller: two floats run a relay pump, an ACS712 checks that current really flows, and alarms catch a dead pump.

    Board
    Arduino Uno R3
    Parts
    Float switch, ACS712 current sensor, relay module, mini water pump, slide switch, +4 more
    Level
    Intermediate
    Open in the simulator
  • Delta-T monitor, drawn in the Mokxi editor

    Delta-T monitor

    Two DS18B20s on one wire read supply and return air: the drop across the coil is judged only while the cooling call runs and has settled.

    Board
    Arduino Uno R3
    Parts
    DS18B20 temperature sensor, float switch, relay module, slide switch, resistor, +1 more
    Level
    Advanced
    Open in the simulator