Project ideas by part

Projects with an ACS712 current sensor

6 Mokxi projects use an ACS712 current sensor (1 beginner, 4 intermediate and 1 advanced). They run on Arduino Uno boards. Here are all of them, from “Motor current meter” to “Motor starter”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Motor current meter”, a beginner project that needs an ACS712 current sensor, a push button, a DC motor and 2 more parts.
  • All of them run on an Arduino Uno, so that is the one board you need.
  • The parts used most here are the push button (4 projects), the slide switch (4) and the LED (3). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the ACS712 current sensor part page for its pins and what each one does.
Projects

6 projects ready to run

  • Motor current meter, drawn in the Mokxi editor

    Motor current meter

    An ACS712 in a 6 V gear motor’s lead and a 16x2 I2C LCD: the current now and the highest seen.

    Board
    Arduino Uno R3
    Parts
    ACS712 current sensor, push button, DC motor, bench power supply, I2C LCD
    Level
    Beginner
    Open in the simulator
  • Home energy monitor with EmonLib, drawn in the Mokxi editor

    Home energy monitor with EmonLib

    A ZMPT101B and an ACS712 feed EmonLib on an Uno: volts, amps, real power and power factor on an I2C LCD, with the watt hours used adding up.

    Board
    Arduino Uno R3
    Parts
    AC voltage sensor, ACS712 current sensor, signal generator, slide switch, resistor, +1 more
    Level
    Intermediate
    Open in the simulator
  • Panel load monitor, drawn in the Mokxi editor

    Panel load monitor

    Four ACS712 sensors on four breaker circuits, with low-voltage stand-in loads: OK, WARNING over 80% and OVERLOAD over 100% on RGB LEDs.

    Board
    Arduino Uno R3
    Parts
    LED, resistor, RGB LED, ACS712 current sensor, bench power supply
    Level
    Intermediate
    Open in the simulator
  • GFCI concept demo (not a real GFCI), drawn in the Mokxi editor

    GFCI concept demo (not a real GFCI)

    Two ACS712 sensors compare the hot and neutral current of a 12 V lamp and a relay latches open on a 60 mA imbalance: a teaching model.

    Board
    Arduino Uno R3
    Parts
    DC jack and adapter, ACS712 current sensor, relay module, filament lamp, resistor, +2 more
    Level
    Intermediate
    Open in the simulator
  • Sump pump controller, drawn in the Mokxi editor

    Sump pump controller

    A teaching model of a sump controller: two floats run a relay pump, an ACS712 checks that current really flows, and alarms catch a dead pump.

    Board
    Arduino Uno R3
    Parts
    Float switch, ACS712 current sensor, relay module, mini water pump, slide switch, +4 more
    Level
    Intermediate
    Open in the simulator
  • Motor starter, drawn in the Mokxi editor

    Motor starter

    START and a fail-safe STOP, a relay and a small DC motor, and an ACS712 that feeds an inverse-time overload trip with a manual RESET.

    Board
    Arduino Uno R3
    Parts
    Push button, resistor, LED, limit switch, ACS712 current sensor, +4 more
    Level
    Advanced
    Open in the simulator