Project ideas by part

Projects with a TB6612FNG motor driver

4 Mokxi projects use a TB6612FNG motor driver, all intermediate. They run on Arduino Uno boards. Here are all of them, from “TB6612 robot drive” to “Scanning obstacle rover”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “TB6612 robot drive”, an intermediate project that needs a TB6612FNG motor driver, a DC motor and a battery: AA.
  • All of them run on an Arduino Uno, so that is the one board you need.
  • The parts used most here are the DC motor (3 projects), the 2WD robot car chassis (1) and the HC-SR04 ultrasonic sensor (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the TB6612FNG motor driver part page for its pins and what each one does.
Projects

4 projects ready to run

  • TB6612 robot drive, drawn in the Mokxi editor

    TB6612 robot drive

    Two gearbox motors on a TB6612FNG from a four-AA pack, with the SparkFun library: forward, half speed, a spin, reverse, a brake and standby.

    Board
    Arduino Uno R3
    Parts
    TB6612FNG motor driver, DC motor, battery: AA
    Level
    Intermediate
    Open in the simulator
  • Line-following cart, drawn in the Mokxi editor

    Line-following cart

    A five-channel line tracker, a TB6612FNG and two gearbox motors on a 2S 18650 pack.

    Board
    Arduino Uno R3
    Parts
    Line tracker, TB6612FNG motor driver, DC motor, battery: AA
    Level
    Intermediate
    Open in the simulator
  • DC throttle with momentum, drawn in the Mokxi editor

    DC throttle with momentum

    A knob, a direction switch and a brake button drive a DC motor through a TB6612, easing up to speed and down again like a heavy train.

    Board
    Arduino Uno R3
    Parts
    Slide switch, push button, potentiometer, TB6612FNG motor driver, DC motor
    Level
    Intermediate
    Open in the simulator
  • Scanning obstacle rover, drawn in the Mokxi editor

    Scanning obstacle rover

    A robot with an ultrasonic sensor on a servo neck. Blocked, it stops, looks right, ahead and left, picks the clearest way and turns that way.

    Board
    Arduino Uno R3
    Parts
    TB6612FNG motor driver, 2WD robot car chassis, servo motor, HC-SR04 ultrasonic sensor
    Level
    Intermediate
    Open in the simulator