Project ideas by part

Projects with an LM358 op-amp

4 Mokxi projects use an LM358 op-amp (2 beginner and 2 intermediate). They run on Arduino Uno boards, and 3 need no board at all. Here are all of them, from “741 vs LM358 on 5 V” to “LM358 amplifier on a scope”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “741 vs LM358 on 5 V”, a beginner project that needs an LM358 op-amp, an LM741 op-amp (uA741), a potentiometer and 1 more part.
  • Arduino Uno runs 1 of them and 3 need no board at all. Start on the board you have, or on an Arduino Uno if you are buying one.
  • The parts used most here are the potentiometer (3 projects), the photoresistor (1) and the LED (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the LM358 dual op-amp part page for its pins and what each one does.
Projects

4 projects ready to run

  • 741 vs LM358 on 5 V, drawn in the Mokxi editor

    741 vs LM358 on 5 V

    A 741 and an LM358 follow the same knob on a 5 V supply: the LM358 goes from 0 to 3.5 V, the 741 never leaves 1.5 to 3.5 V.

    Board
    No board
    Parts
    LM358 dual op-amp, LM741 op-amp (uA741), potentiometer, multimeter
    Level
    Beginner
    Open in the simulator
  • Rail-to-rail op-amps on 3.3 V, drawn in the Mokxi editor

    Rail-to-rail op-amps on 3.3 V

    An LM358, an MCP6002, an LMV358 and an MCP6004 follow one knob on 3.3 V.

    Board
    No board
    Parts
    Potentiometer, LM358 dual op-amp, multimeter, MCP6002 dual rail-to-rail op-amp, LMV358 dual rail-to-rail op-amp, +1 more
    Level
    Beginner
    Open in the simulator
  • LM358 dark switch with an Arduino, drawn in the Mokxi editor

    LM358 dark switch with an Arduino

    An LM358 comparator lights an LED when the LDR goes dark, past a threshold set by a knob.

    Board
    Arduino Uno R3
    Parts
    Photoresistor, resistor, potentiometer, LM358 dual op-amp, LED
    Level
    Intermediate
    Open in the simulator
  • LM358 amplifier on a scope, drawn in the Mokxi editor

    LM358 amplifier on a scope

    An LM358 non-inverting amplifier with a gain of 3.2 on one 5 V supply: a 0.2 to 1.0 V sine in, 0.64 to 3.20 V out, and a clip at 3.5 V to find.

    Board
    No board
    Parts
    Function generator, LM358 dual op-amp, resistor, oscilloscope
    Level
    Intermediate
    Open in the simulator