Project ideas by part

Projects with a TMP36 sensor

4 Mokxi projects use a TMP36 sensor (3 beginner and 1 intermediate). They run on Arduino Uno boards. Here are all of them, from “Temperature-controlled fan” to “Thermometer”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Temperature-controlled fan”, a beginner project that needs a TMP36 sensor and a fan module.
  • All of them run on an Arduino Uno, so that is the one board you need.
  • The parts used most here are the 16x2 character LCD (1 project), the LED (1) and the WS2812 NeoPixel LEDs (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the TMP36 temperature sensor part page for its pins and what each one does.
Projects

4 projects ready to run

  • Temperature-controlled fan, drawn in the Mokxi editor

    Temperature-controlled fan

    A TMP36 reads the room and an L9110 fan module runs faster as it warms: off under 24 C, 40% at 24 C and full speed by 32 C.

    Board
    Arduino Uno R3
    Parts
    TMP36 temperature sensor, fan module
    Level
    Beginner
    Open in the simulator
  • Warm-hands meter, drawn in the Mokxi editor

    Warm-hands meter

    A TMP36 on A0 and three LEDs: hold the sensor and the LEDs light one by one as it warms two, four and six degrees over the room.

    Board
    Arduino Uno R3
    Parts
    TMP36 temperature sensor, resistor, LED
    Level
    Beginner
    Open in the simulator
  • Love meter, drawn in the Mokxi editor

    Love meter

    Hold a TMP36 between your fingers and a bar of ten WS2812B LEDs fills from pink to red with your warmth.

    Board
    Arduino Uno R3
    Parts
    TMP36 temperature sensor, resistor, WS2812 NeoPixel LEDs
    Level
    Beginner
    Open in the simulator
  • Thermometer, drawn in the Mokxi editor

    Thermometer

    A TMP36 on A0 and the temperature on a 16x2 LCD in four-bit mode, with the high and low on the second row.

    Board
    Arduino Uno R3
    Parts
    TMP36 temperature sensor, 16x2 character LCD
    Level
    Intermediate
    Open in the simulator