Project ideas by part

Projects with a DRV8833 motor driver

5 Mokxi projects use a DRV8833 motor driver (4 intermediate and 1 advanced). They run on Arduino Uno boards. Here are all of them, from “Bumper car” to “Arcade claw machine”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Bumper car”, an intermediate project that needs a DRV8833 motor driver, a robot car chassis and a limit switch.
  • All of them run on an Arduino Uno, so that is the one board you need.
  • The parts used most here are the 2WD robot car chassis (4 projects), the limit switch (3) and the TCRT5000 line sensor (2). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the DRV8833 motor driver part page for its pins and what each one does.
Projects

5 projects ready to run

  • Bumper car, drawn in the Mokxi editor

    Bumper car

    A 2WD robot car on a DRV8833 with two lever microswitches for bumpers. It drives until a bumper is hit, then backs off and turns away from that side.

    Board
    Arduino Uno R3
    Parts
    DRV8833 motor driver, 2WD robot car chassis, limit switch
    Level
    Intermediate
    Open in the simulator
  • Maze-solving robot, drawn in the Mokxi editor

    Maze-solving robot

    A two-wheel robot with three Sharp infrared distance sensors.

    Board
    Arduino Uno R3
    Parts
    DRV8833 motor driver, 2WD robot car chassis, IR distance sensor
    Level
    Intermediate
    Open in the simulator
  • Sumo robot, drawn in the Mokxi editor

    Sumo robot

    A mini-sumo robot with an ultrasonic eye and two edge sensors.

    Board
    Arduino Uno R3
    Parts
    DRV8833 motor driver, 2WD robot car chassis, HC-SR04 ultrasonic sensor, TCRT5000 line sensor
    Level
    Intermediate
    Open in the simulator
  • Robot vacuum behaviors, drawn in the Mokxi editor

    Robot vacuum behaviors

    A cleaning robot with two bumpers and a cliff sensor.

    Board
    Arduino Uno R3
    Parts
    DRV8833 motor driver, 2WD robot car chassis, limit switch, TCRT5000 line sensor
    Level
    Intermediate
    Open in the simulator
  • Arcade claw machine, drawn in the Mokxi editor

    Arcade claw machine

    A complete claw machine you can watch: a stepper gantry with home switches, winch, servo claw and prizes in the cabinet, a coin switch.

    Board
    Arduino Uno R3
    Parts
    A4988 stepper driver, joystick, claw machine cabinet, arcade button, DRV8833 motor driver, +5 more
    Level
    Advanced
    Open in the simulator