Temperature and humidity
Put an SHT31 in the brood box and read the colony's own thermostat: brood held near 34.5 C, whatever the weather.
Open it in the simulatorBuild a hive monitor beekeepers can trust: weight trends, brood temperature, hive sound, a swarm watch and LoRa reports.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Put an SHT31 in the brood box and read the colony's own thermostat: brood held near 34.5 C, whatever the weather.
Open it in the simulatorCombine two clues into one alarm: a weight drop of 1.5 kg in ten minutes, and piping heard in the last half hour.
Open it in the simulatorThe whole monitor: weight, brood climate, sound, the swarm watch and LoRa reports with the season so far.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Weight and the brood nest's climate.
Weigh a whole beehive with load cells and an HX711, and read the trend: a nectar flow puts weight on, a swarm takes it off in minutes.
0 of 4 steps
Put an SHT31 in the brood box and read the colony's own thermostat: brood held near 34.5 C, whatever the weather.
0 of 4 steps
Hive sound, and an alarm that needs two clues.
Listen to a colony: the pitch from zero crossings, the level as RMS, and a careful watch on the band where young queens pipe.
0 of 4 steps
Combine two clues into one alarm: a weight drop of 1.5 kg in ten minutes, and piping heard in the last half hour.
0 of 4 steps
Ten bytes over LoRa, then a season of data.
Send the hive's state home in ten bytes over LoRa: weight, brood temperature, humidity, sound and a report number.
0 of 4 steps
The whole monitor: weight, brood climate, sound, the swarm watch and LoRa reports with the season so far.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a smart beehive is part of the maker track, a ladder of courses from zero to expert.
Build a feeder that keeps a diary: motion, a scale that weighs every visitor, a squirrel guard, a visit log and a daily report.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a smart beehive are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Temperature and humidity, Swarm signs and Project: a season of data.
With "Hive weight", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.