Seed weight
Hang the feeder from a load cell: the seed left in the hopper, and every visitor weighed and sized as it lands.
Open it in the simulatorBuild a feeder that keeps a diary: motion, a scale that weighs every visitor, a squirrel guard, a visit log and a daily report.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Hang the feeder from a load cell: the seed left in the hopper, and every visitor weighed and sized as it lands.
Open it in the simulatorWrite every visit to VISITS.CSV on microSD with the time from a DS3231: when, how heavy, what size, and how long it stayed.
Open it in the simulatorThe whole feeder: motion, landings and departures with times and weights, a log on the card, and the evening report.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Motion, and a scale that weighs every visitor.
Count visits with a PIR motion sensor: one per rising edge, held for a few seconds, so a bird hopping about is one visit and not twenty.
0 of 4 steps
Hang the feeder from a load cell: the seed left in the hopper, and every visitor weighed and sized as it lands.
0 of 4 steps
Keep the squirrels out, and write every visit down.
Shut a servo gate over the seed when anything over 300 g sits on the perch, and open it again only after 10 seconds clear.
0 of 4 steps
Write every visit to VISITS.CSV on microSD with the time from a DS3231: when, how heavy, what size, and how long it stayed.
0 of 4 steps
An evening report, then the whole feeder.
At 20:00 every evening, sum up the day: visits by size, seed eaten, the share left, the busiest hour and a refill reminder.
0 of 4 steps
The whole feeder: motion, landings and departures with times and weights, a log on the card, and the evening report.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a smart bird feeder is part of the maker track, a ladder of courses from zero to expert.
A keypad with a constant-time check, RFID, a fingerprint, a relay-driven bolt, an EEPROM log and a three-factor door, with honest security notes.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a smart bird feeder are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Seed weight, Logging visits and Project: a bird diary.
With "Visit detection", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.