Become a USB keyboard
Turn every key into a shortcut and add a knob that turns the volume. Why volume is a different kind of key, and how the board sends both.
Open it in the simulatorTwelve keys, a volume knob, three layers and a screen on a Pro Micro that plugs in as a keyboard.
0 of 3 done
3 lessons in 2 chapters, about 2 hours on a simulated SparkFun Pro Micro. Free, in your browser, every step checked by the simulator.
Turn every key into a shortcut and add a knob that turns the volume. Why volume is a different kind of key, and how the board sends both.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Read a key matrix, then send real shortcuts and media keys over USB.
Wire a keypad to a Pro Micro and read it with the Keypad library. Why a matrix saves pins, and how the board tells which key you pressed.
0 of 4 steps
Turn every key into a shortcut and add a knob that turns the volume. Why volume is a different kind of key, and how the board sends both.
0 of 4 steps
Add layers, a lamp for each and a screen that shows what just happened.
Finish the pad: three layers you switch with the knob, a lamp for each, and an OLED that shows what every key just did.
0 of 5 steps
All 3 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a macro pad is part of the maker track, a ladder of courses from zero to expert.
Faders, drum pads, a knob and an encoder on a Pro Micro, sending real MIDI bytes you can read.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 3 lessons of Build a macro pad are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated SparkFun Pro Micro with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 2 hours: 3 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Become a USB keyboard.
With "Twelve keys on seven pins", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.