Pads that play drums
Four buttons become drum pads: Note On when you hit one, Note Off when you let go, on the channel General MIDI keeps for drums.
Open it in the simulatorFaders, drum pads, a knob and an encoder on a Pro Micro, sending real MIDI bytes you can read.
0 of 3 done
3 lessons in 2 chapters, about 2 hours on a simulated SparkFun Pro Micro. Free, in your browser, every step checked by the simulator.
Four buttons become drum pads: Note On when you hit one, Note Off when you let go, on the channel General MIDI keeps for drums.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Turn faders into Control Change and pads into notes, one byte at a time.
Two slide pots become Control Change messages: three bytes at 31250 baud. Read a voltage, squeeze it into 0 to 127 and send it the way synths expect.
0 of 4 steps
Four buttons become drum pads: Note On when you hit one, Note Off when you let go, on the channel General MIDI keeps for drums.
0 of 4 steps
Add a knob, program changes and a panic button.
Finish the controller: a knob for one more control, an encoder that flips through a synth's sounds, and a button that silences everything at once.
0 of 4 steps
All 3 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a MIDI controller is part of the maker track, a ladder of courses from zero to expert.
A rhythm game in three builds: notes that fall in time, buttons that judge your timing, then the whole game with combos and a high score.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
A Pro Micro, a rotary encoder (KY-040), an LED, a slide potentiometer and a pushbutton: a MIDI controller you play with your hands.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 3 lessons of Build a MIDI controller are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated SparkFun Pro Micro with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 2 hours: 3 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Pads that play drums.
With "Faders that speak MIDI", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.