Project ideas by part

Projects with a voltage regulator

4 Mokxi projects use a voltage regulator (3 beginner and 1 advanced). None of them needs a board. Here are all of them, from “7805 voltage regulator circuit” to “Solar sensor node”. Each card says what the project does, the board and parts it needs and its level, and Open in the simulator runs it in your browser in one click, with no account.

First project

How to pick your first one

  • Start with “Plus and minus 5 V”, a beginner project that needs a DC voltage source, a voltage regulator and a resistor.
  • The parts used most here are the LED (2 projects) and the capacitor (1). With those on hand, most of this list is open to you.
  • Before you build one on a real bench, open the voltage regulator part page for its pins and what each one does.
Projects

4 projects ready to run

  • 7805 voltage regulator circuit, drawn in the Mokxi editor

    7805 voltage regulator circuit

    A 9 V battery into a 7805 with its 0.33 uF and 0.1 uF capacitors: 5 V out to an LED, until the battery sags below about 6.7 V.

    Board
    No board
    Parts
    Battery: AA, voltage regulator, capacitor, resistor, LED
    Level
    Beginner
    Open in the simulator
  • Plus and minus 5 V, drawn in the Mokxi editor

    Plus and minus 5 V

    Two 12 V sources make a split supply, and a 7805 and a 7905 turn it into +5 V and -5 V, each with a load on it.

    Board
    No board
    Parts
    DC voltage source, voltage regulator, resistor
    Level
    Beginner
    Open in the simulator
  • USB to 3.3 V, drawn in the Mokxi editor

    USB to 3.3 V

    A USB-C breakout on a computer port feeds an AP2112K-3.3 low dropout regulator, which lights an LED at 3.3 V.

    Board
    No board
    Parts
    USB power, voltage regulator, resistor, LED
    Level
    Beginner
    Open in the simulator
  • Solar sensor node, drawn in the Mokxi editor

    Solar sensor node

    A 6 V panel charges an 18650 through a TP4056, an MCP1700 makes 3.3 V, and a Pro Mini reports temperature, humidity.

    Board
    Arduino Pro Mini, 3.3 V 8 MHz
    Parts
    Arduino Pro Mini, solar panel, li-ion charger, battery: AA, voltage regulator, +2 more
    Level
    Advanced
    Open in the simulator