Boards

The ESP32-S3-CAM

The common ESP32-S3 camera dev board: 8 MB of PSRAM, an OV2640 socket, USB-C and 44 pins named by GPIO.

The overview, with examples running, is on the board page.

What it is

The same ESP32-S3 as the ESP32-S3 DevKitC-1, on a camera board. Two 22-pin headers run down the long edges 0.9 inch apart. The silkscreen numbers are GPIO numbers, so a sketch writes 48 for GPIO 48. It runs the same firmware as the DevKitC-1, so its examples run here too. The sketch runs from flash, so it can be as big as the Arduino IDE allows (1,310,720 bytes) rather than the 128 KB of RAM a simulator would otherwise give it.

The pins

The header is the DevKitC-1's, in its order: 3V3, 3V3b, RST, 4, 5, 6, 7, 15, 16, 17, 18, 8, 3, 46, 9, 10, 11, 12, 13, 14, 5V, G down the left, and Gb, TX (GPIO 43), RX (GPIO 44), 1, 2, 42, 41, 40, 39, 38, 37, 36, 35, 0 (BOOT), 45, 48, 47, 21, 20, 19, Gc, Gd down the right. This is this model's reading of the common board's pinout: check it against yours before you wire power to a pin.

The camera

The OV2640 is drawn, not simulated. Its lines are ordinary GPIOs here (XCLK 15, SIOD 4, SIOC 5, VSYNC 6, HREF 7, PCLK 13, and D0 to D7 on 11, 9, 8, 10, 12, 18, 17 and 16). A sketch that calls esp_camera_init gets ESP_ERR_NOT_FOUND (0x105) and a line on the serial monitor saying that no camera is simulated, so its own "Camera init failed" path runs. Everything else on the board runs.

PSRAM

The board has 8 MB of octal PSRAM. It is not modeled. On the real board GPIO 35, 36 and 37 are the PSRAM's pins and must not be used; here they are ordinary pins.

The user LED

The board's LED is on GPIO 48 (a WS2812 on the real board). Here it is an ordinary LED that lights when the pin is HIGH, so LED_BUILTIN is 48 and the built-in Blink runs on it with no wiring. The real board's colors are not modeled.

WiFi

It joins Mokxi's simulated network, with the network name and password as properties of the board. There is no radio and no 802.11. See the WiFi article.