Fingerprint
Let an R30x fingerprint sensor match a finger against its own library, and open for enrolled fingers only.
Open it in the simulatorA keypad with a constant-time check, RFID, a fingerprint, a relay-driven bolt, an EEPROM log and a three-factor door, with honest security notes.
0 of 6 done
6 lessons in 2 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Let an R30x fingerprint sensor match a finger against its own library, and open for enrolled fingers only.
Open it in the simulatorDemand something you have, something you are and something you know, in order and in time, with the log and the lockout behind them.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
A code, a latch, a card and a finger, each on its own.
Take a code from a 4x3 keypad without echoing it, and compare it in constant time so the timing of a wrong guess gives nothing away.
0 of 5 steps
Switch a 12 V solenoid bolt through a relay for three seconds on the right code, and see why fail secure and fail safe are different promises.
0 of 4 steps
Read MIFARE card UIDs with an MFRC522, open for the one on the list, and learn why a UID on its own is a name, not a password.
0 of 4 steps
Let an R30x fingerprint sensor match a finger against its own library, and open for enrolled fingers only.
0 of 4 steps
Logs, lockouts and three factors together.
Lock out three wrong codes in a row, for longer each time, and keep a ring of the last 16 events in EEPROM that survives the power going off.
0 of 4 steps
Demand something you have, something you are and something you know, in order and in time, with the log and the lockout behind them.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a smart lock is part of the maker track, a ladder of courses from zero to expert.
Keep a Mars crew alive on one Uno: CO2 and its scrubber, cabin pressure and leaks, an interlocked airlock and alarms that latch.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An Uno, a keypad (4x3 telephone), an RFID reader (MFRC522), a fingerprint sensor (R30x / AS608) and a relay module: a door that opens only for you.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a smart lock are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Fingerprint and Project: a three-factor door.
With "Keypad codes", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.