Pressure
Read the cabin pressure, catch a leak from how fast it falls, and learn why oxygen is a share of the pressure, not a percentage.
Open it in the simulatorKeep a Mars crew alive on one Uno: CO2 and its scrubber, cabin pressure and leaks, an interlocked airlock and alarms that latch.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Read the cabin pressure, catch a leak from how fast it falls, and learn why oxygen is a share of the pressure, not a percentage.
Open it in the simulatorCAUTION and WARNING levels, alarms that latch until someone acknowledges them, and the worst problem always at the top.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
CO2, the scrubber that removes it, and the pressure that holds it all in.
Count the CO2 in a cabin with an SCD41, learn why 5000 ppm is the limit, and work out how long a crew takes to reach it.
0 of 5 steps
Pull CO2 out of the air with a scrubber fan, switched by two thresholds so it never chatters, and work out the chemistry a mission has to carry.
0 of 5 steps
Read the cabin pressure, catch a leak from how fast it falls, and learn why oxygen is a share of the pressure, not a percentage.
0 of 5 steps
An airlock that cannot be opened wrong, and alarms that get heard.
Two doors that are never open together: an interlock in one function, a state machine for pumping and filling, and the relay that runs the pump.
0 of 6 steps
CAUTION and WARNING levels, alarms that latch until someone acknowledges them, and the worst problem always at the top.
0 of 6 steps
Put it all together into one panel worth sharing.
Put it all together: CO2, pressure, the scrubber, the airlock and the alarms on one panel that keeps a crew alive.
0 of 7 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a space habitat controller is part of the maker track, a ladder of courses from zero to expert.
The clacking departure board: 40 flaps on a 28BYJ-48, 51.2 steps a flap kept exact, hall sensor homing, a character map, and four modules on shift registers.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
An Uno, a CO2 sensor (SCD41) and a pressure, humidity and temperature sensor (BME280): a life support panel that keeps a crew alive.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a space habitat controller are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Pressure and Alarms.
With "Air in a sealed room", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.