A text terminal
Drive a screen one byte at a time with eight data lines, a write enable and a clock, and make Enter, Backspace and Escape do what a terminal does.
Open it in the simulatorFrom a CPU of NAND gates to a machine with a keyboard, a screen, a hex monitor and a BASIC that saves your programs.
0 of 6 done
6 lessons in 3 chapters, about 7 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Drive a screen one byte at a time with eight data lines, a write enable and a clock, and make Enter, Backspace and Escape do what a terminal does.
Open it in the simulatorProgram the machine in a small BASIC: a calculator at the prompt, variables, numbered lines, FOR loops, IF and GOTO, and the errors that tell you what went wrong.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
A CPU, a keyboard decoded by hand, and a screen driven a byte at a time.
Run a CPU of four thousand NAND gates, step it one instruction at a time, write it a loop in machine code, and find what it would need to be a home computer.
0 of 5 steps
Decode a PS/2 keyboard by hand: an interrupt on the clock, eleven bits a frame, odd parity, and set 2 make and break codes turned into letters.
0 of 5 steps
Drive a screen one byte at a time with eight data lines, a write enable and a clock, and make Enter, Backspace and Escape do what a terminal does.
0 of 6 steps
A machine code monitor, then a BASIC with an interpreter you can read.
Look at memory, change it a byte at a time, and run it: a 1976-style hex monitor that loads Kestrel machine code you assemble by hand.
0 of 5 steps
Program the machine in a small BASIC: a calculator at the prompt, variables, numbered lines, FOR loops, IF and GOTO, and the errors that tell you what went wrong.
0 of 6 steps
Type in a program, play it, change it and save it.
Type in a game the way magazines printed them in 1980, play it, make it harder, save it to EEPROM and load it back after wiping the machine.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a home computer is part of the maker track, a ladder of courses from zero to expert.
Infrared blasters on two Unos: coded 38 kHz shots, team codes, health bars, reloads, sound and a two-team game.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a home computer are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 7 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: A text terminal and BASIC-lite.
With "The Kestrel CPU", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.