Team codes
Pack a team into the command byte, pick the team from a jumper, light the bar in the team color, and ignore friendly fire.
Open it in the simulatorInfrared blasters on two Unos: coded 38 kHz shots, team codes, health bars, reloads, sound and a two-team game.
0 of 6 done
6 lessons in 3 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Pack a team into the command byte, pick the team from a jumper, light the bar in the team color, and ignore friendly fire.
Open it in the simulatorGive each blaster a six-shot clip, an empty click, and a reload that takes a second and a half and leaves you open while it runs.
Open it in the simulatorPlay a whole game: tag-outs reported back to the shooter, respawns, reloads, and the first team to three tag-outs wins.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Fire a coded infrared packet and put a team inside it.
Fire a coded infrared packet: a 38 kHz carrier, an NEC frame with an address and a command, and a receiver on the other blaster that decodes it as a hit.
0 of 6 steps
Pack a team into the command byte, pick the team from a jumper, light the bar in the team color, and ignore friendly fire.
0 of 5 steps
A health bar, tag-outs, respawns and a clip that runs dry.
Show five health on a WS2812 bar, take one per enemy hit with a half-second safe window, and tag out at zero with a respawn.
0 of 5 steps
Give each blaster a six-shot clip, an empty click, and a reload that takes a second and a half and leaves you open while it runs.
0 of 5 steps
Sounds for every event and a whole two-team game.
Give every event its own sound from a one-note buzzer: a fire chirp, a hit buzz, an empty click, reload beeps and a long tone when you are out.
0 of 5 steps
Play a whole game: tag-outs reported back to the shooter, respawns, reloads, and the first team to three tag-outs wins.
0 of 5 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a laser tag system is part of the maker track, a ladder of courses from zero to expert.
A strip of LEDs as one column of pixels: pictures as columns, BMPs from microSD, timing for your walk and your name in light on a long exposure.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a laser tag system are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Team codes, Reloads and Project: a two-team game.
With "IR shots", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.