Start signal
Stage both cars in their start beams, run a drag strip countdown on a signal head with beeps, and time each lane's reaction from green.
Open it in the simulatorLight gates, a start tree and an LCD: time two lanes to the millisecond, catch false starts and run a pinewood derby.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Stage both cars in their start beams, run a drag strip countdown on a signal head with beeps, and time each lane's reaction from green.
Open it in the simulatorTurn two times into a result: first and second, the winning margin and a dead heat inside a millisecond, laid out cleanly on a 20x4 I2C LCD.
Open it in the simulatorRun a pinewood derby: four cars over four heats, every car in both lanes, false starts re-run, a champion on the LCD, then build the real track.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Read four light gates and run a drag strip countdown.
Read four slotted light gates, learn why blocked reads HIGH, catch a car crossing the line once, and turn its time in the beam into a speed.
0 of 5 steps
Stage both cars in their start beams, run a drag strip countdown on a signal head with beeps, and time each lane's reaction from green.
0 of 5 steps
Time each lane to the millisecond and put the places on the screen.
Time each lane to the millisecond with micros(), see why the loop must never wait, and call a DNF when a car does not arrive.
0 of 4 steps
Turn two times into a result: first and second, the winning margin and a dead heat inside a millisecond, laid out cleanly on a 20x4 I2C LCD.
0 of 5 steps
Red lights, time slips and a whole derby with lanes swapped for fairness.
Catch a car that leaves before green with a red light, then print a real drag strip time slip: reaction, ET and total, and a win on a holeshot.
0 of 5 steps
Run a pinewood derby: four cars over four heats, every car in both lanes, false starts re-run, a champion on the LCD, then build the real track.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a race timer is part of the maker track, a ladder of courses from zero to expert.
Count a Geiger tube with interrupts, read background with its uncertainty, turn counts into dose, and keep a diary on microSD.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a race timer are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Start signal, Places on the display and Project: a derby track.
With "Light gates", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.