Background
Measure the radiation that is always there with a running minute, and read every number with its Poisson uncertainty.
Open it in the simulatorCount a Geiger tube with interrupts, read background with its uncertainty, turn counts into dose, and keep a diary on microSD.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Measure the radiation that is always there with a running minute, and read every number with its Poisson uncertainty.
Open it in the simulatorMake every count a click you can hear, mute it, and raise an alarm over 1 uSv/h that does not cry wolf at random bursts.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Pulses, interrupts, background and the square root of N.
Count the pulses of a Geiger tube with an interrupt, see what polling would miss, and meet the square root that rules every count.
0 of 5 steps
Measure the radiation that is always there with a running minute, and read every number with its Poisson uncertainty.
0 of 4 steps
Dose math, a log on microSD, and clicks and alarms.
Turn counts per minute into microsieverts an hour with the tube's factor, see how approximate that is, and add it up over a year.
0 of 4 steps
Write the raw counts to microSD every 30 seconds, safely, and read them back. Rates can be worked out later; counts cannot be recovered from rates.
0 of 4 steps
Make every count a click you can hear, mute it, and raise an alarm over 1 uSv/h that does not cry wolf at random bursts.
0 of 5 steps
Put it all together into a logger worth carrying.
Put it all together: a counter that clicks, alarms, totals your dose and keeps a diary of the places you took it.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a radiation logger is part of the maker track, a ladder of courses from zero to expert.
Build the low-voltage side of a reflow oven: a thermocouple, an SSR, solder profiles, PID tracking and the safety cutoffs that make it trustworthy.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a radiation logger are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Background and Clicks and alarms.
With "Counts per minute", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.