SD bitmaps
Read a 24-bit BMP from microSD by its real rules: a 54-byte header, rows stored bottom first, blue-green-red pixels and rows padded to four bytes.
Open it in the simulatorA strip of LEDs as one column of pixels: pictures as columns, BMPs from microSD, timing for your walk and your name in light on a long exposure.
0 of 6 done
6 lessons in 2 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Read a 24-bit BMP from microSD by its real rules: a 54-byte header, rows stored bottom first, blue-green-red pixels and rows padded to four bytes.
Open it in the simulatorType your name, set the speed, count down and paint it in rainbow light, then take the stick out at night with a camera.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
One column of pixels, pictures stored sideways, and bitmaps from a card.
Treat a 16-LED strip as one column of pixels: a lamp test, then any column typed as a 16-bit number lit on the stick.
0 of 4 steps
Store a picture sideways as columns in flash, build text from a 5x7 font doubled to the stick's height, and play them out on START.
0 of 4 steps
Read a 24-bit BMP from microSD by its real rules: a 54-byte header, rows stored bottom first, blue-green-red pixels and rows padded to four bytes.
0 of 5 steps
Timing for your walk, camera settings, and your name in light.
Set the time per column with a knob and work out what it means at walking speed, so the picture comes out the right shape.
0 of 4 steps
Set up the camera for light painting, work out the exposure the picture needs, and sync it with a three-blink countdown on the stick.
0 of 4 steps
Type your name, set the speed, count down and paint it in rainbow light, then take the stick out at night with a camera.
0 of 4 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a light painting stick is part of the maker track, a ladder of courses from zero to expert.
A 28BYJ-48 lift stepped from its coil table, a servo gate that routes, a debounced marble counter, a WS2812 count bar and a jam alarm, for a machine that runs forever.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a light painting stick are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 2 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: SD bitmaps and Project: write your name in light.
With "LED columns", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.