The whole sword
Blade, motion and a real sound font together: a DFPlayer Mini plays ignition, hum, swing, clash and retract, and a gauge shows the battery.
Open it in the simulatorA light saber style sword in three builds: a blade that ignites, motion you can hear, then the whole hilt with a sound font.
0 of 3 done
3 lessons in 1 chapter, about 3 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Blade, motion and a real sound font together: a DFPlayer Mini plays ignition, hum, swing, clash and retract, and a gauge shows the battery.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Light the blade, give it motion and sound, then put the whole hilt together.
Twenty-four WS2812 LEDs on one data wire and a single button. Ignite the blade from the hilt up, retract it, and pick its color.
0 of 5 steps
An MPU6050 feels every move of the hilt. Tell a swing from a clash with a gyroscope and an accelerometer, and give each its own sound on a piezo.
0 of 5 steps
Blade, motion and a real sound font together: a DFPlayer Mini plays ignition, hum, swing, clash and retract, and a gauge shows the battery.
0 of 8 steps
All 3 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a laser sword is part of the maker track, a ladder of courses from zero to expert.
Twelve keys, a volume knob, three layers and a screen on a Pro Micro that plugs in as a keyboard.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
A 24-LED blade, a motion sensor, a sound board, a charge gauge and a battery pack.
Open the kitPick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 3 lessons of Build a laser sword are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 3 hours: 3 lessons in 1 chapter, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: The whole sword.
With "Light the blade", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.