Messages between nodes
Eight bytes on the air: addresses, a message format of your own, hardware acks, retries on top, and message numbers that catch repeats.
Open it in the simulatorThree Unos on nRF24L01 radios run a three-room escape game: addresses, acks, retries, state sync, hints and resets from a game master panel.
0 of 6 done
6 lessons in 3 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Eight bytes on the air: addresses, a message format of your own, hardware acks, retries on top, and message numbers that catch repeats.
Open it in the simulatorPut every room back for the next group with one command, check every node acknowledged it, and confirm with a ping.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Puzzles that know their answers, and the packets that carry the news.
Meet the network: a game master and two puzzle nodes, a keypad code in the Lab, a key card in the Vault and a hidden magnet in the Study.
0 of 5 steps
Eight bytes on the air: addresses, a message format of your own, hardware acks, retries on top, and message numbers that catch repeats.
0 of 5 steps
A panel that knows every room, sends hints and puts it all back.
A table of what the game master believes about every room, lights that show it, and a ping that makes the belief match the truth.
0 of 5 steps
Send hints across the network to the right room, count them, and make each one a little more direct than the last.
0 of 5 steps
Put every room back for the next group with one command, check every node acknowledged it, and confirm with a ping.
0 of 4 steps
Rooms in order, a clock, and an escape worth sharing.
The whole game: rooms that unlock in order, a 60-minute clock, hints that cost time, and an escape time at the end.
0 of 7 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a networked escape room is part of the maker track, a ladder of courses from zero to expert.
A garage stop light from scratch: an ultrasonic sensor that measures with sound, LEDs that turn green, yellow and red, smoothing for messy echoes, sleep when the car is parked, and notes for mounting it for real.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a networked escape room are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Messages between nodes and Resets.
With "Puzzle nodes", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.