Cadence
Add a crank sensor on the second interrupt: pedal turns a minute, the gear worked out from wheel turns per pedal turn, and coasting spotted.
Open it in the simulatorHall switches on interrupts, speed and distance from a tire, cadence, automatic lights, an OLED and a ride log on microSD.
0 of 6 done
6 lessons in 3 chapters, about 5 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
Add a crank sensor on the second interrupt: pedal turns a minute, the gear worked out from wheel turns per pedal turn, and coasting spotted.
Open it in the simulatorPut speed in big digits, distance, cadence and the lights on an SSD1306 OLED, with a text-only library that leaves RAM for the card.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Magnets, interrupts, speed, distance and cadence.
Catch a spoke magnet with an A3144 Hall switch on an interrupt, count every pass the instant it happens, and throw out bounces.
0 of 5 steps
Turn the time for one wheel turn into km/h and the count of turns into meters, for a 2105 mm road tire, with whole-number math.
0 of 5 steps
Add a crank sensor on the second interrupt: pedal turns a minute, the gear worked out from wheel turns per pedal turn, and coasting spotted.
0 of 4 steps
Lights that switch themselves and a screen you can read on the move.
Switch the headlight on at dusk and off in daylight from a light sensor, with two levels so it never flickers, while the wheel keeps counting.
0 of 4 steps
Put speed in big digits, distance, cadence and the lights on an SSD1306 OLED, with a text-only library that leaves RAM for the card.
0 of 4 steps
A ride log on microSD and a bike computer of your own.
Log every ride to RIDE.CSV on a microSD card, second by second, end the ride after ten still seconds with a summary, and ride on without a card.
0 of 5 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a bike computer is part of the maker track, a ladder of courses from zero to expert.
A tiller pilot for the simulator: a tilt-compensated compass with declination, a limited rudder, a PID heading loop that knows 359 from 1 and ignores waves, and great-circle navigation to GPS waypoints. Never for real navigation.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a bike computer are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 5 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: Cadence and Display.
With "Wheel magnet", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.