The UV index
An LTR390 counts ultraviolet light. Turn counts into the UV index with the datasheet's sensitivity, name the band, work out a time to burn, and measure visible light too.
Open it in the simulatorA solar weather station on an Uno: wind, rain, the air and UV, packed into 14 bytes over LoRa to a base station that prints the day.
0 of 6 done
6 lessons in 3 chapters, about 6 hours on a simulated Arduino Uno R3. Free, in your browser, every step checked by the simulator.
An LTR390 counts ultraviolet light. Turn counts into the UV index with the datasheet's sensitivity, name the band, work out a time to burn, and measure visible light too.
Open it in the simulatorPack every reading into 14 bytes, big-endian, with wind and direction sharing two bytes, send them over LoRa, and work out the time on air and the duty cycle.
Open it in the simulatorEach lesson opens when the one before it is done, and each chapter ends in a project.
Reed switches and a resistor ladder, then calibrated chips for the air and the sun.
The weather meter kit has no electronics inside: wind speed from an anemometer's clicks, direction from a vane's resistor ladder, and rain from a tipping bucket.
0 of 5 steps
A BME280 for temperature, humidity and pressure, the dew point from the first two, and the sea-level correction that makes pressure comparable with a weather map.
0 of 5 steps
An LTR390 counts ultraviolet light. Turn counts into the UV index with the datasheet's sensitivity, name the band, work out a time to burn, and measure visible light too.
0 of 6 steps
Solar power that lasts, and a radio link that sips.
A panel, a LiPo cell and an INA219: charging by day, carrying the station by night, a daily energy budget that does not add up, and sleep that fixes it.
0 of 6 steps
Pack every reading into 14 bytes, big-endian, with wind and direction sharing two bytes, send them over LoRa, and work out the time on air and the duty cycle.
0 of 6 steps
A page of the day, from 14 bytes.
The whole station sends to the base station, which prints a page of readings: lows and highs, the day's gust and rain, UV and the link, all from 14 bytes.
0 of 6 steps
All 6 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Build a backyard weather station is part of the maker track, a ladder of courses from zero to expert.
Hall switches on interrupts, speed and distance from a tire, cadence, automatic lights, an OLED and a ride log on microSD.
Open the next courseFollow the starter kit you already own, then build a claw machine, a balance bot, a handheld console or an LED cube, each a short course checked by the simulator.
See every course on the trackEvery lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 6 lessons of Build a backyard weather station are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every lesson runs on a simulated Arduino Uno R3 with its parts on the canvas, and the simulator checks each step as you go. When you want to build it for real, the same wiring and code work on a real board.
About 6 hours: 6 lessons in 3 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
Each chapter ends in a project that puts it together: The UV index and LoRa uplink.
With "Wind and rain", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.