Part

Air quality, CCS811

eCO2 in ppm and TVOC in ppb over I2C at 0x5A on the CJMCU-811, boot mode, drive modes and nINT.

See every part
  • 8 pins
  • 2 settings
  • In 1 project
Drawn live by the editor's own code, at the size you see it.
Air quality, CCS811 as drawn in the Mokxi simulator
At a glance

The Air quality, CCS811 in brief

What it is, and every setting the properties panel gives it.

Family
Sensors
Pins
8
eco2
400
tvoc
0
Pins

8 pins

Named as the editor names them, so a wire lands where you expect it.

Pin
What it does
VCC
Supply, 3.3 V. The chip runs from 1.8 to 3.6 V and this board has no regulator.
GND
Ground.
SCL
I2C. The board carries the pull-ups.
SDA
I2C. The board carries the pull-ups.
WAK
nWAKE, active low. The chip only listens while it is low: tie it to GND, or to a pin you hold low while you talk to it. Left unwired, nothing answers.
INT
nINT, an open-drain output that goes low when a sample is ready (or crosses a threshold), if the sketch asks.
RST
nRESET, active low; pulled up inside the chip, so it can stay unwired.
ADD
The address: low (the board's pull-down) is 0x5A, high is 0x5B.
How it is modeled

What is true about the Air quality, CCS811, here

In its help article’s own words: what the simulation gets right, and where it stops.

Not modeled

The gas chemistry. The readings are the sliders, sample by sample; the 48 hour burn-in, the 20 minute run-in, the automatic baseline correction and the temperature and humidity compensation are not simulated (ENV_DATA and BASELINE keep what is written). RAW_DATA is a fixed stand-in, NTC reads zero, and the heater faults, the firmware download and the ten minutes of idle the datasheet asks for before a slower mode are not checked. Too much voltage on VCC does no damage here.

From CCS811 air quality sensor, in full.

Projects

See the Air quality, CCS811 in a project

One built-in project uses it. It opens in the editor, already wired.

Boards

The boards it is shown on

This board has a built-in project with the Air quality, CCS811 in it.

Wire up the Air quality, CCS811

Open the editor and push it into the breadboard. It is free, and it runs on your own machine.