Part

Pressure sensor, BMP388

Pressure and temperature over I2C at 0x77 or 0x76, raw counts with Bosch trim, oversampling and IIR filter.

See every part
  • 6 pins
  • 2 settings
  • In 1 project
Drawn live by the editor's own code, at the size you see it.
Pressure sensor, BMP388 as drawn in the Mokxi simulator
At a glance

The Pressure sensor, BMP388 in brief

What it is, and every setting the properties panel gives it.

Family
Sensors
Pins
6
temperature
22
pressure
1013.25
Pins

6 pins

Named as the editor names them, so a wire lands where you expect it.

Pin
What it does
VIN
Supply, 3.3 or 5 V on the board (the chip runs from 1.65 to 3.6 V; the board's regulator and level shifters feed it).
GND
Ground.
SCL
I2C. The board carries the pull-ups. Adafruit's board prints them SCK and SDI, their SPI names.
SDA
I2C. The board carries the pull-ups. Adafruit's board prints them SCK and SDI, their SPI names.
SDO
The address bit. Left alone (the board pulls it up) the address is 0x77; to GND it is 0x76, so two can share a bus.
INT
Data ready interrupt, when the sketch turns it on.
How it is modeled

What is true about the Pressure sensor, BMP388, here

In its help article’s own words: what the simulation gets right, and where it stops.

Not modeled

SPI (this board's I2C only), the FIFO and its interrupts, the sensor time counter and the I2C watchdog. The readings are the sliders to the bit at the oversampling set, without the noise oversampling removes; the real part is within 0.5 hPa and 0.3 °C, typically. The sheet does not say when the chip flags a configuration error: here normal mode is refused, with conf_err, when a measurement would not fit in the ODR period, the check Bosch's driver makes.

From BMP388 barometric pressure sensor, in full.

Projects

See the Pressure sensor, BMP388 in a project

One built-in project uses it. It opens in the editor, already wired.

Boards

The boards it is shown on

This board has a built-in project with the Pressure sensor, BMP388 in it.

Wire up the Pressure sensor, BMP388

Open the editor and push it into the breadboard. It is free, and it runs on your own machine.