Find your kit
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitThe brushed DC machine as a component: torque from current, back EMF, the torque-speed line, generator mode, where the watts go, three ways to brake, and an Uno motor dyno you build yourself.
0 of 7 done
7 lessons in 7 chapters, about 5 hours on a simulated breadboard. Free, in your browser, every step checked by the simulator.
Each lesson opens when the one before it is done, and each chapter ends in a project.
Torque is current, from stall to free running.
A motor's torque is its current times a constant: a stalled motor at 1.2 V that cannot beat its friction, the start at 2 V, full speed at 6 V, the inrush at switch-on, and a lower-resistance winding that pulls twice the amps.
0 of 6 steps
A spinning motor pushes back, in proportion to speed.
A spinning motor is a generator pushing back: speed proportional to voltage, the voltage it makes when the supply is cut, the constant that links them, and why the running current is so small.
0 of 5 steps
Free speed, stall and free current, and the line between.
Read a real motor's numbers off the bench: free speed, stall current and free current of a TT gear motor, the straight-line torque-speed curve they define, and a hobby motor that spins at twelve thousand rpm.
0 of 6 steps
The same machine driving a load.
The same machine run backward: a spinning motor driving current into a load, terminal voltage against load, the matched load that takes the most power, and the energy it is spending as it slows.
0 of 4 steps
Power in, copper loss and shaft power.
Where the watts go: input power, copper loss in the winding, and the rest turned into shaft power, at full and half voltage, and what a better motor saves.
0 of 5 steps
Coast, dynamic braking and plugging.
Three ways to stop a motor: coast, dynamic braking with a short or a resistor, and plugging with a reversed supply that stops it and spins it the other way.
0 of 4 steps
An Uno motor dyno that measures a real motor.
An Uno, an L9110S, an INA219 and an encoder gear motor become a motor dyno: sweep the PWM, find the dead band, the free speed, the free current and the back EMF constant, then change the supply, prove the speed follows, find the driver's limit, and brake it.
0 of 5 steps
All 7 lessons, in order, each with what it covers. Any of them opens in the editor right away.
Every lesson runs in the simulator with nothing to buy. When you want the real thing, these kits have the parts.
Pick the starter kit you own and run every lesson in its manual with the same parts on the same pins.
See every kitYes. All 7 lessons of DC motors and generators are free and run in your browser, with nothing to install and no parts to buy before you start.
No. Every circuit is built on a simulated breadboard, and the simulator checks each step as you go. When you want to build it for real, the same parts and wiring work on a real bench.
About 5 hours: 7 lessons in 7 chapters, each one a few short steps. Your progress is kept, so you can stop after any lesson and pick up where you left off.
With "Torque and current", and each lesson builds on the one before it. New to circuits? Electronics basics is the course that starts from zero.